Amorphous Particles Embedded in hcp Mg Grains of Melt-Quenched Mg<SUB>98</SUB>Cu<SUB>1</SUB>Gd<SUB>1</SUB> Alloys

Melt Protection of Mg-Al Based Alloys

This paper reports the current status of Mg melt protection in view to identify near-future challenges, but also opportunities, for Mg melt protection of Mg-Al based alloys. The goal is to design and manufacture sustainable Mg alloys for resource efficiency, recycling and minimising waste. Among alternative cover gas technologies for Mg melt protection other than SF6: commercially available tec...

Martensitic Transformation in Microcrystalline Melt-Quenched Fe-Ni Alloys

The features of martensite transformation in Fe (31 32)% Ni melt-quenched alloys are considered. The meltquenching was realized by spinning technique with variable parameters. The influence of the melt-quenching on structural and kinetics transformation parameters is revealed. In particular Ms point is shown to decrease but volume percentage of athermal martensite is found to be invariable with...

Ultrafast characterization of phase-change material crystallization properties in the melt-quenched amorphous phase.

Phase change materials are widely considered for application in nonvolatile memories because of their ability to achieve phase transformation in the nanosecond time scale. However, the knowledge of fast crystallization dynamics in these materials is limited because of the lack of fast and accurate temperature control methods. In this work, we have developed an experimental methodology that enab...

Crystallization study of “melt quenched” amorphous GeTe by transmission electron microscopy for phase change memory applications

EXPERIMENTALl ANALYSIS OF PARTITION COEFFICIENT IN Al-Mg ALLOYS

Because the partition coefficient is one of the most important parameters affecting microsegregation, the aim of this research is to experimentally analyse the partition coefficient in Al-Mg alloys. In order to experimentally measure the partition coefficient, a series of quenching experiments during solidification were carried out. For this purpose binary Al-Mg alloys containing 6.7 and 10.2 w...