An experimental study of water BLEVE
نویسندگان
چکیده
منابع مشابه
An Experimental Study of the Steel Cylinder Quenching in Water-based Nanofluids
In this study, some parameters such as quenching and boiling curves of a stainless steel cylindrical rod 80 mm long and having a diameter of 15 mm were experimentally obtained in saturate pure water and two nanofluids (SiO2 and TiO2) with 0.01 wt%. The cylinder was vertically lowered into the pool of saturated water and its temporal center temperature was measured by a the...
متن کاملThermal performance enhancement of automobile radiator using water-CuO nanofluid: an experimental study
In the present paper, the effect of water-CuO nanofluid on the radiator heat transfer of an automobile, Peugeot 405 XU7 engine type is investigated experimentally. The experiments are carried out for the radiator water (water-ethylene glycol with a volume fraction of 80-20, respectively) as a base fluid and water-CuO nanofluid with the volume fraction of 0.5% and 1%. Sodium Dodecyl Sulfate (SDS...
متن کاملAn Experimental Study of CO2-low Salinity Water Alternating Gas Injection in Sandstone Heavy Oil Reservoirs
Several studies have shown that oil recovery significantly increased by low salinity water flooding (LSWF) in sandstones. However, mechanism of oil recovery improvement is still controversial. CO2 that develops buffer in presence of water is expected as a deterrent factor in LSWF efficiency based on mechanism of IFT reduction due to pH uprising. No bright evidence in literature suppo...
متن کاملAn Experimental Investigation of Magnetized Water Effect on Formation Damage
In oil industries, water injection into oil reservoirs for pressure maintenance, oil displacement, and oil recovery is a common technique. Formation damage during water injection is a major problem in this process. Formation damage from the incompatibility of formation water (FW) and injection water (IW) causes a reduction in the permeability around the injection wells. Therefore, it is necessa...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Process Safety and Environmental Protection
سال: 2020
ISSN: 0957-5820
DOI: 10.1016/j.psep.2020.04.029