An overvoltage driver with inductive adder pulse for fast switching of series-connected MOSFETs module
نویسندگان
چکیده
منابع مشابه
Power Module with Series-connected MOSFETs in Flip-chip Configuration
Power module design is needed for high system performance and reliability, especially in terms of high efficiency and high power density. Low parasitic impedance and thermal management is desired for the lower power loss and device stress. For power module with high efficiency and improved breakdown voltage, this thesis proposes a novel series-connected power MOSFETs module. Three IRF7832 MOSFE...
متن کاملAnalysis of Series-Connected MOSFETs for Gate Delay Optimization
A series-connected MOSFET structure has been analyzed in order to optimize the discharge time of complex CMOS logic gates in a submicrometric technology. The study has been focused to improve discharge time fixing the area of the diffusion region and regarding the operation point of the different transistors in the chain. Results for a 9 series-connected NMOS chain are presented. Effects due to...
متن کاملDriving and Layout Design for Fast Switching Super-Junction MOSFETs
Power MOSFET technology has been developed towards higher cell density for lower on-resistance. There are, however, silicon limits for significant reduction in the onresistance with the conventional planar MOSFET technology because of its exponential increase in onresistance according to the increase of blocking capability. One of efforts to overcome the silicon limit is superjunction technolog...
متن کاملShaping the output pulse of a linear-transformer-driver module
We demonstrate that a wide variety of current-pulse shapes can be generated using a linear-transformerdriver (LTD) module that drives an internal water-insulated transmission line. The shapes are produced by varying the timing and initial charge voltage of each of the module’s cavities. The LTD-driven accelerator architecture outlined in [Phys. Rev. ST Accel. Beams 10, 030401 (2007)] provides a...
متن کاملA New Linear Inductive Voltage Adder Driver for the Saturn Accelerator
Saturn is a dual-purpose accelerator. It can be operated as a large-area flash x-ray source for simulation testing or as a Z-pinch driver especially for K-line x-ray production. In the first mode, the accelerator is fitted with three concentric-ring 2-MV electron diodes, while in the Zpinch mode the current of all the modules is combined via a post-hole convolute arrangement and driven through ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: AIP Advances
سال: 2019
ISSN: 2158-3226
DOI: 10.1063/1.5116117