An Unknown Input Observer–EFIR Combined Estimator for Electrohydraulic Actuator in Sensor Fault-Tolerant Control Application
نویسندگان
چکیده
منابع مشابه
Fault-Tolerant Control Allocation: an Unknown Input Observer based approach
This paper focuses on the use of unknown input observers for detection and isolation of actuator and effector faults with control reconfiguration in overactuated systems. The control allocation actively uses input redundancy in order to make relevant faults observable. The case study of an overactuated marine vessel supports theoretical developments.
متن کاملActuator Fault-tolerant Control Design Based on Reconfigurable Reference Input
The prospective work reported in this paper explores a new approach in order to enhance the performance of an Active Fault Tolerant Control System. This proposed technique is based on a modified recovery/trajectory control system which considered a reconfigurable reference input when performance degradation occurs on system due to faults in actuators dynamics. The added value of this work is to...
متن کاملFault tolerant control allocation using unknown input observers
This paper focuses on the use of unknown input observers for detection and isolation of actuator and effector faults with control reconfiguration in overactuated systems. The proposed approach consists in tuning the observer parameters in order to make the filters decoupled from faults affecting selected groups of actuators or effectors. The control allocation actively uses input redundancy in ...
متن کاملFault Tolerant Control of Wind Turbines Using Unknown Input Observers
This paper presents a scheme for accommodating faults in the rotor and generator speed sensors in a wind turbine. These measured values are important both for the wind turbine controller as well as the supervisory control of the wind turbine. The scheme is based on unknown input observers, which are also used to detect and isolate these faults. The scheme is tested on a known benchmark for FDI ...
متن کاملUnknown Input Observers and Fault Tolerant Control Allocation ∗
This research report focuses on the use of unknown input observers for detection and isolation of actuator and effector faults with control reconfiguration in overactuated systems. The proposed approach consists in tuning the observer parameters in order to make the filters decoupled from faults affecting selected groups of actuators or effectors. The control allocation actively uses input redu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE/ASME Transactions on Mechatronics
سال: 2020
ISSN: 1083-4435,1941-014X
DOI: 10.1109/tmech.2020.3013609