Analog interface for remote measurements by differential-transformer inductive sensors
نویسندگان
چکیده
منابع مشابه
Microcontroller-based interface circuit for inductive sensors
This work proposes a fully-digital interface circuit for the measurement of inductive sensors using a low-cost microcontroller (μC) and without any intermediate active circuit. Apart from the μC and the sensor, the circuit just requires an external resistor and a reference inductance so that two RL circuits with a high-pass filter (HPF) topology are formed. The μC appropriately excites such RL ...
متن کاملWeight Measurements by Using Simple Optical-Fiber Sensors (RESEARCH NOTE)
The use of different optical-fiber sensors for weighing measurements is Abstract described. By using three different mechanical stressing mechanisms, the operation of the fiber-to-fiber transducer systems are tested and the results are presented. Parameters such as sensitivity, hysteresis, resolution, and dynamic range are measured. A comparison of the results has shown that the sensor system m...
متن کاملAnalog Wavelet Transformer Draft #
This paper describes the theory and implementation in CMOS technology of a circuit which performs analog wavelet decompositions of a one-dimensional (e.g., sound) input. The circuit is based on the Analog VLSI techniques described by Carver Mead in Analog VLSI and Neural Systems 1]. The analog wavelet outputs are the output of a logarithmically scaled set of bandpass lters; each band is sampled...
متن کاملPassive and Self-Powered Autonomous Sensors for Remote Measurements
Autonomous sensors play a very important role in the environmental, structural, and medical fields. The use of this kind of systems can be expanded for several applications, for example in implantable devices inside the human body where it is impossible to use wires. Furthermore, they enable measurements in harsh or hermetic environments, such as under extreme heat, cold, humidity or corrosive ...
متن کاملCharge-transfer-based Signal Interface for Differential Capacitive Sensors
We propose a circuit to directly connect a differential capacitive sensor to a microcontroller unit (MCU), which is based on the charge-transfer method and does not need any calibration component. The performance has been tested by emulating the differential capacitive sensor with discrete components. The major uncertainty sources are residual stray capacitances. The maximal deviation obtaine...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Eastern-European Journal of Enterprise Technologies
سال: 2014
ISSN: 1729-4061,1729-3774
DOI: 10.15587/1729-4061.2014.21078