Analysis of Al-Si Layer on Steel Sheet during Thermo Mechanical Processing Using Microscopic Methods
نویسندگان
چکیده
منابع مشابه
Quantitative analysis of thermo-mechanical behavior in 414 stainless steel using flow curves and processing maps
The hot deformation behavior of a typical martensitic stainless steel containing 2.1% Ni was investigated by means of the compression test in the strain rate range of 0.001-1 s-1 and temperature range of 950-1150 °C. The flow behavior of the steel was evaluated using the flow stress curves and flow softening map and by microstructural investigation. Taking into account of the strain effect on t...
متن کاملThe Effect of Controlled Thermo Mechanical Processing on the Properties of a High Strength Steel
In this paper, an ultra low carbon High Strength Low Alloy Grade Steel was subjected to a two-step forging process and this was followed by different post cooling methods. The highest strength was obtained at a faster cooling rate due to the highly dislocated acicular ferrite structure with the fine precipitation of microalloying carbides and carbonitrides. At a slow cooling rate, the strength ...
متن کاملEnhancement of mechanical properties of low carbon steel based on heat treatment and thermo-mechanical processing routes
Thermal treatments and thermo-mechanical processing routes were applied on a conventional structural steel (st37 steel: 0.12C-1.11Mn-0.16Si) for improvement of tensile properties and enhancement of work-hardening behavior. Full annealing resulted in a sheet with coarse ferrite grains and pearlite colonies arranged alternatively in distinct bands, which showed high ductility, low strength, and t...
متن کاملThermo-mechanical analysis of magnesium alloy cylinder heads using a two-layer viscoplasticity model
Loading conditions and complex geometry have led the cylinder heads to become the most challenging parts of diesel engines. The aim of this study is to compare the distribution of temperature and stress in the aluminum and magnesium cylinder heads under thermo-mechanical loads. The three-dimensional model of the cylinder heads was simulated in abaqus software and a two-layer viscoplasticity mod...
متن کاملthe effect of controlled thermo mechanical processing on the properties of a high strength steel
in this paper, an ultra low carbon high strength low alloy grade steel was subjected to a two-step forging processand this was followed by different post cooling methods. the highest strength was obtained at a faster coolingrate due to the highly dislocated acicular ferrite structure with the fine precipitation of microalloying carbides andcarbonitrides. at a slow cooling rate, the strength fel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Manufacturing Technology
سال: 2018
ISSN: 1213-2489,1213-2489
DOI: 10.21062/ujep/175.2018/a/1213-2489/mt/18/5/769