Analysis of Critical Heat Flux in Two-Phase Thermosyphon. Relationship between Maximum Falling Liquid Rate and Critical Heat Flux.
نویسندگان
چکیده
منابع مشابه
Measurement and correlation of critical heat flux in two-phase micro-channel heat sinks
Critical heat flux (CHF) was measured for a water-cooled micro-channel heat sink containing 21 parallel 215· 821 lm channels. Tests were performed with deionized water over a mass velocity range of 86–368 kg/ms, inlet temperatures of 30 and 60 C, at an outlet pressure of 1.13 bar. As CHF was approached, flow instabilities induced vapor backflow into the heat sink’s upstream plenum, which signif...
متن کاملCritical heat flux around strongly heated nanoparticles.
We study heat transfer from a heated nanoparticle into surrounding fluid using molecular dynamics simulations. We show that the fluid next to the nanoparticle can be heated well above its boiling point without a phase change. Under increasing nanoparticle temperature, the heat flux saturates, which is in sharp contrast with the case of flat interfaces, where a critical heat flux is observed fol...
متن کاملThe Effect of Linear Change of Tube Diameter on Subcooled Flow Boiling and Critical Heat Flux
One of the major industry problems is the flow boiling, where reaching to the critical heat flux (CHF) condition can lead to a temperature jump and damage of the systems. In the present study, the effects of a uniform change in tube diameter on subcooled flow boiling and CHF was numerically investigated. The Euler-Euler model was used to investigate the relationship between the two liquid and v...
متن کاملExperimental Study for Investigating the Mechanism of Heat Transfer near the Critical Heat Flux in Nucleate Pool Boiling
Heat transfer coefficient in nucleate pool boiling near critical heat flux at least one orderhigher than the convectional heat transfer modes. In this paper, an experimental setup isdesigned and fabricated to investigate the mechanism of heat transfer from boiling surface tobulk liquid near critical heat flux. The images of pool boiling near the high heat flux regionreveals that the individual ...
متن کاملNano-Engineering the Boiling Surface for Optimal Heat Transfer Rate and Critical Heat Flux
The effects on pool boiling characteristics such as critical heat flux and the heat transfer coefficient of different surface characteristics such as surface wettability, roughness, morphology, and porosity are not well understood. Layer-by-layer nanoparticle coatings were used to modify the surface of a sapphire heater to control the surface roughness, the layer thickness, and the surface chem...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1995
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.61.4101