Analysis of non-isothermal mold filling process in Resin Transfer Molding (RTM)? and Structural Reaction Injection Molding (SRIM)
نویسندگان
چکیده
منابع مشابه
Numerical Modeling of Mold Filling and Curing in Non-Isothermal RTM Process (RESEARCH NOTE)
Resin Transfer Molding (RTM) is a composite manufacturing process. A preformed fiber is placed in a closed mold and a viscous resin is injected into the mold. In this paper, a model is developed to predict the flow pattern, extent of reaction and temperature change during filling and curing in a thin rectangular mold. A numerical simulation is presented to predict the free surface and its inter...
متن کاملAnalysis of the Three Dimensional Mold-filling Process in Injection Molding
For the three decades, the mold-filling of injection molding process was modeled as Hele-Shaw model. However, this model can not consider the 3D effect. In this paper, numerical simulations of three dimensional mold-filling during the filling phase were performed. The governing equations were discretized by segregated finite element method, which used equal order interpolation for pressure and ...
متن کاملModeling of Resin Transfer Molding
Resin Transfer Molding (RTM), as a method for the manufacture of advanced ber reinforced composite materials, is attractive because it ooers the possibility of lower manufacturing costs and more complex shapes than traditional methods. A major issue in this new manufacturing process is the elimination of void spaces in the resin ll operation, so that products with high quality are manufactured....
متن کاملPrecision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملsimulation of injection molding process including mold filling and compound curing
the present work reports and discusses the results of a 3d simulation of the injection molding process of a rubber compound that includes the mold flling stage and material curing, using the computer code is developed in “udf” part of the fluent 6.3 cae software. the data obtained from a rheometer (mdr 2000) is used to characterize the rubber material in order to fnd the cure model parameters ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Computational Mechanics
سال: 1995
ISSN: 0178-7675,1432-0924
DOI: 10.1007/s004660050045