Analysis of process parameters in surface grinding using single objective Taguchi and multi-objective grey relational grade
نویسندگان
چکیده
منابع مشابه
Multi-objective optimization in WEDM of D3 tool steel using integrated approach of Taguchi method & Grey relational analysis
In this paper, wire electrical discharge machining of D3 tool steel is studied. Influence of pulse-on time, pulse-off time, peak current and wire speed are investigated for MRR, dimensional deviation, gap current and machining time, during intricate machining of D3 tool steel. Taguchi method is used for single characteristics optimization and to optimize all four process parameters simultaneous...
متن کاملMulti-objective optimization in Turning of EN31 steel using Taguchi based grey relational analysis
Machining can be outlined as the process of taking away material from a work piece in the grade of chips. During a machining process, isolated of the energy is turned into heat energy through the detritions yielded between the tool and the work piece and the plastic deformation of the work material in the machining zone. Turning is charmed by several constituents, for example, the cutting speed...
متن کاملMulti-objective Optimization of Edm Parameters Using Grey Relation Analysis
This paper involves the multi-objective optimization of process parameters of AlSi10Mg/9 wt% alumina/3 wt% graphite in Electrical Discharge Machining for obtaining minimum surface roughness, minimum tool wear rate and maximum material removal rate. The important machining parameters were selected as peak current, flushing pressure and pulse-on time. Experiments were conducted by selecting diffe...
متن کاملUsing Gray Relational Analysis and Taguchi Technique in Solving Multi-objective Problems for Turning Operation of Austenitic Stainless Steel
In this study, the application of gray relational analysis (GRA) and Taguchi method in multi-criteria process parameters selection of turning operation has been investigated. The process responses under study are material removal rate (MRR) and surface roughness (SR); in turn, the input parameters include cutting speed, feed rate, depth of cut and nose radius of the cutting tool. The proposed a...
متن کاملusing gray relational analysis and taguchi technique in solving multi-objective problems for turning operation of austenitic stainless steel
in this study, the application of gray relational analysis (gra) and taguchi method in multi-criteria process parameters selection of turning operation has been investigated. the process responses under study are material removal rate (mrr) and surface roughness (sr); in turn, the input parameters include cutting speed, feed rate, depth of cut and nose radius of the cutting tool. the proposed a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Perspectives in Science
سال: 2016
ISSN: 2213-0209
DOI: 10.1016/j.pisc.2016.04.077