Analysis of reinforced concrete slabs under blast loading
نویسندگان
چکیده
منابع مشابه
Behaviour of fibre reinforced concrete slabs
This paper presents a comparison of the properties of concrete slabs when two types of fibres are added. One specimen had no fibres and acted as a control specimen. The remaining four specimens had steel and polypropylene fibres added in the volumetric ratio of 0.5% and 1.0%. The dimensions of the slab specimens were 820×820×80 mm and were supported by four rollers at their edges. A displacemen...
متن کاملNumerical Analysis of Punching Shear Failure of Reinforced Concrete Slabs
Nearly no load bearing behaviour of reinforced concrete members allows such varied interpretations and complex discussions as the shear behaviour. Especially the three-dimensional problem of the punching shear failure of reinforced concrete members is internationally discussed. Nevertheless up to now, there is no unified design approach or even an overall accepted design model. Especially for l...
متن کاملExperimental Modal Analysis of Reinforced Concrete Square Slabs
The aim of this paper is to perform experimental modal analysis (EMA) of reinforced concrete (RC) square slabs. EMA is the process of determining the modal parameters (Natural Frequencies, damping factors, modal vectors) of a structure from a set of frequency response functions FRFs (curve fitting). Although, experimental modal analysis (or modal testing) has grown steadily in popularity since ...
متن کاملBehaviour of Reinforced Fibrous Concrete Beams under Reversed Cyclic Loading
When earthquakes occur, energy released by the earthquake gets induced into the structure as ground motion and this energy has to be dissipated for safety reasons. To release seismic energy, the structure should damage in such a way that on one hand, collapse of structure should not occur and on the other hand, after the earthquake, damage should be economically feasible to repair. To avoid the...
متن کاملReinforced Concrete Wall Response under Uni- and Bi- Directional Loading
During an earthquake, structures are subjected to both horizontal and vertical shaking. Most structures are rather insensitive to variations in the vertical acceleration history and primary considerations are given to the impact of the horizontal shaking on the behavior of structures. In the laboratory, however, most component tests are carried out under uni-directional horizontal loading to si...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2018
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2018.06.035