Analysis of Roller Shaft Pad Steam Machine
نویسندگان
چکیده
منابع مشابه
Numerical Analysis of Grease Film Characteristics in Tapered Roller Bearing Subject to Shaft Deflection
The shaft deflection is one of critical factors that deteriorate the grease lubrication state inside the tapered roller bearings (TRBs). So, in this paper, on the premise of the TRB subjected to the combined loads and the shaft is deflected, the grease lubrication model at the TRB contacts was constructed, in which the interaction loads, linear and angular displacements of the bearing parts wer...
متن کاملFinite Element Analysis and Design Improvement of Film Picking Forks Roller Tooth in Field Cleaning Machine
In this paper the mechanical analysis of the film picking forks roller tooth in field -cleaning machine was done. A finite element analysis model was built and used by the non-linear finite element analysis method. It is obtained from the result of post-processing calculation and analysis that according to the Fourth Strength Theory, the maximum equivalent stress on the pole tooth root under th...
متن کاملDynamic analysis of three-cylinder engine with balancing shaft
Three-cylinder linear engines are designed to minimize, reduce fuel consumption and pollution. The disadvantages of this type of engine, heavy vibration inherent in them. this study aims to balance Three-cylinder linear engines with a balancing shaft. First, the dynamic analysis of these types of engines identifies unbalanced sources. The results of the dynamic analysis showed that the inertial...
متن کاملStrain-based fatigue analysis of wheelchairs on a double roller fatigue machine.
Results are presented from an experimental program that recorded the outputs of strain gages mounted on two wheelchair frames (one manual, one power) as the wheelchairs were run on a double roller fatigue machine. Rectangular strain gage rosettes were attached to the frames near the cross tube center pin and on the side frame behind a front caster. Thirty data sets were recorded from each roset...
متن کاملSimulation and Application of Loose Tooling Forging for Heavy Grinding Roller Shaft Forgings
Article history: Received: 08.11.2013. Received in revised form: 12.01.2013. Accepted: 14.01.2014. The grinding roller shaft is a key part of the grinding roller. It has a step-shaped shaft with different round cross-sections and 1850 mm × 1110 mm rectangular cross-section. If the general method of free forging is used, the upsetting diameter of ingot will reach 2900 mm, and 8400 t hydraulic pr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Research in Applied Science and Engineering Technology
سال: 2020
ISSN: 2321-9653
DOI: 10.22214/ijraset.2020.31844