Analysis of the isothermal forced flow chemical vapour infiltration process. Part II: Experimental study
نویسندگان
چکیده
منابع مشابه
Grinding Effect of C/C-SiC Composites Prepared by Isothermal Chemical Vapour Infiltration during Braking Process
A kind of 2.5-dimensional C/C-SiC composites was fabricated by using Isothermal Chemical Vapour Infiltration process (ICVI). Frictional properties of this material were evaluated by using MM-1000 under dry condition. Average dynamic friction coefficient of it was 0.16, static friction coefficient and average coefficient stability were 0.15 and 0.56, respectively. However, weight wear rate was l...
متن کاملGas Flow Simulation of Chemical Vapour Infiltration in a Vertical Hot-wall Reactor
Deposition of silicon carbide (Sic) into two types of capillaries (1.5 mm dia. x 6 mm depth, 1.0 mm dia. x 4 mm depth) has been attempted by a vertical hot-wall-type chemical vapour infiltration (CVI) process using an SiCl4-CH4-H2 system. Dependence of the deposition temperature (Tdep) and the total gas pressure (Ptot) on the thickness distribution of Sic in the two types of the capillaries (pa...
متن کاملChemical Vapour Infiltration (cvi) of Silicon Carbide Fibre Preforms
An alternative fabrication technique is proposed for ceramic matrix / ceramic fibre composites involving filling a fibre fabric preform with a SiSi N slurry and subsequently reaction bonding. For the first processing step in this process, chemical vapour infiltration (CVI) was evaluated as a means of both binding together and protecting the fibres. Sic (Nicalon) fibre p re fom consisting of thr...
متن کاملExperimental Study on Sintering and Infiltration Process of Metal Part Fabricated by Mold Decomposed Injection Sculpturing
Mold Decomposed injection sculpturing (Mold DIS) process which integrates injection and sculpturing in layered manufacture is a novel rapid prototyping technique. In this paper a wax mold is fabricated through DIS process, the 316L stainless steel slurry is then cast into the mold. After curing and drying, the wax mold is melted and the green part is obtained. The purpose of this paper is to st...
متن کاملconsequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir
there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the European Ceramic Society
سال: 1995
ISSN: 0955-2219
DOI: 10.1016/0955-2219(95)00062-y