Analysis of Weldment by Using Finite Element Method(3) - Residual Stress and Distortion in Weldment -
نویسندگان
چکیده
منابع مشابه
The development of finite element software for creep deformation and damage analysis of weldment
This paper presents the development of finite element software for creep deformation and damage analysis of weldment. The development and benchmark test of the software under plane stress, plane strain, axisymmetric, and 3 dimensional cases were reported in previous work [1]. This paper primarily consists of two parts: 1) the structure of the new FE software and the existing FE library applied ...
متن کاملInvestigating the Effect of Joint Geometry of the Gas Tungsten Arc Welding Process on the Residual Stress and Distortion using the Finite Element Method
Although a few models have been proposed for 3D simulation of different welding processes, 2D models are still more effective in design goals, thus more popular due to the short-time analysis. In this research, replacing "time" by the "third dimension of place", the gas tungsten arc welding process was simulated by the finite element method in two dimensions and in a short time with acceptable ...
متن کاملCreep Life Forecasting of Weldment
One of the yet unresolved engineering problems is forecasting the creep lives of weldment in a pragmatic way with sufficient accuracy. There are number of obstacles to circumvent including: complex material behavior, lack of accurate knowledge about the creep material behavior specially about the heat affected zones (HAZ),accurate and multi-axial creep damage models, etc. In general, creep life...
متن کاملFinite Element Simulation of Welding Distortion in Large Structure
Fusion welding is widely used in heavy industries to join different parts together. But sometimes welding-induced distortions cause problems like misalignment during assembling and make costs to remove them. Thus it is imperative to predict and mitigate them to improve weldments quality and also reduce in fabrication costs. This study at first will introduce inherent deformation method for pred...
متن کاملCorrecting the stress-strain curve in hot compression test using finite element analysis and Taguchi method
In the hot compression test friction has a detrimental influence on the flow stress through the process and therefore, correcting the deformation curve for real behavior is very important for both researchers and engineers. In this study, a series of compression tests were simulated using Abaqus software. In this study, it has been employed the Taguchi method to design experiments by the factor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Welding and Joining
سال: 2011
ISSN: 2466-2232
DOI: 10.5781/kwjs.2011.29.4.363