Analysis on start up and heat transfer performance of mercury heat pipe under alternating heating power

نویسندگان

چکیده

Heat pipe may be affected by the high temperature heat source during operation, resulting in unsteady oscillation heating. In this paper, influence of alternating power and period on start-up transfer performance mercury is studied using method equivalent thermal resistance pipe. The results are as follows:1) time heating steady-state basically equal; 2) For heating, changes periodically, increasing or amplitude will lead to increase fluctuation temperature, greater than that changing power. 3) Under condition periodically. increases with amplitude, period.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Heat Transfer Analysis of Heating Plate with Multiple Heat Sources

Preliminary note 3D numerical study of transient heat transfer phenomenon on a solid plate with complex heat sources has been carried out. In order to validate the chosen numerical model, a set of thermographic measurements have been performed on a heating plate sample. The infrared camera provided a number of thermograms showing the development of transient temperature fields on the plate surf...

متن کامل

Experimental Investigation on CuO/Water Nanofluid Effect on the Heat Transfer Rate of Heat Pipe Network

In this study, a new configuration of heat pipes as Heat Pipe Network is introduced. Here, the heat pipe network is designed, constructed and then has been under the performance assessment. This heat pipe network consists of 4 vertical heat pipes connected to evaporator collector from bottom and condenser collector from top. In order to investigate the effect of nanofluids on the thermal effici...

متن کامل

Particle shape effect on heat transfer performance in an oscillating heat pipe

The effect of alumina nanoparticles on the heat transfer performance of an oscillating heat pipe (OHP) was investigated experimentally. A binary mixture of ethylene glycol (EG) and deionized water (50/50 by volume) was used as the base fluid for the OHP. Four types of nanoparticles with shapes of platelet, blade, cylinder, and brick were studied, respectively. Experimental results show that the...

متن کامل

Heat Transfer of Nanofluid in a Double Pipe Heat Exchanger

This paper investigates the enhancement of heat transfer coefficient and Nusselt number of a nanofluid containing nanoparticles (γ-AL2O3) with a particle size of 20 nm and volume fraction of 0.1%-0.3% (V/V). Effects of temperature and concentration of nanoparticles on Nusselt number changes and heat transfer coefficient in a double pipe heat exchanger with counter turbulent flow are investigate...

متن کامل

An experimental investigation of heat transfer of Fe2O3/Water nanofluid in a double pipe heat exchanger

One way to increase the heat transfer is to use perforated twisted tapes with different hole diameters, which largely improve heat transfer with an increase in the heat transfer area at the constant volume and more mixed flow. In the previous studies, the effect of nanofluids with perforated twisted tapes is less studied. In this work, the performance of water / iron oxide nanofluid in a double...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: E3S web of conferences

سال: 2021

ISSN: ['2555-0403', '2267-1242']

DOI: https://doi.org/10.1051/e3sconf/202124801004