Apparent Viscosity of Al-10mass%Cu Semi-solid Alloys.

Optimization of Microstructure and Mechanical Properties of Al-A360 Produced by Semi-Solid Casting

Semi-Solid Casting (SSM) is a new process that could produce globular structures with mechanical properties. The cooling slope method (CLM) is a one of this process that was employed to produce the A360 feedstock. In this method, The dendritic primary phase in the conventionally cast A356 alloy has transformed into a non-dendritic one. In this paper, The molten alloy with the temperature (PT) o...

Al-7Si-Mg Semi-Solid Castings – Microstructure and Mechanical Properties

A Summary of Corrosion Properties of Al-Rich Solid Solution and Secondary Phase Particles in Al Alloys

The heterogeneous structure of Al alloys renders them susceptible to localized corrosion due to the different electrochemical properties existing in the Al-rich solid solution matrix and secondary phase particles. The galvanic interactions between these two phases can result in pit formation either through dissolution of the particles or corrosion of the matrix adjacent to the particles. This d...

Computer simulation of the microstructure and rheology of semi-solid alloys under shear

The rheological behavior of metallic alloys containing both solid and liquid phases is investigated in the low solid fraction range (<50%). This behavior depends on both the solid fraction and the shear rate. The concept of Effective Volume Fraction (EVF) is used to decorrelate the influence of these two parameters. At high shear rate the slurry behaves like a suspension of hard spheres, wherea...

EXPERIMENTALl ANALYSIS OF PARTITION COEFFICIENT IN Al-Mg ALLOYS

Because the partition coefficient is one of the most important parameters affecting microsegregation, the aim of this research is to experimentally analyse the partition coefficient in Al-Mg alloys. In order to experimentally measure the partition coefficient, a series of quenching experiments during solidification were carried out. For this purpose binary Al-Mg alloys containing 6.7 and 10.2 w...