Applicability of Solid Solution Heat Treatments to Aluminum Foams
نویسندگان
چکیده
منابع مشابه
Applicability of Solid Solution Heat Treatments to Aluminum Foams
Present research work evaluates the influence of both density and size on the treatability of Aluminum-based (6000 series) foam-parts subjected to a typical solid solution heat treatment (water quenching). The results are compared with those obtained for the bulk alloy, evaluating the fulfilment of cooling requirements. Density of the foams was modeled by tomography analysis and the thermal pro...
متن کاملCreep of aluminum syntactic foams
Aluminum syntactic foams with densities of 1.2–1.5 g/cm3 were deformed at 500 ◦C under constant uniaxial compressive stresses ranging from to 14 MPa. The foam creep behavior is characterized by a short primary stage and a long secondary stage where the strain rate is constant and inimum, followed by a tertiary stage at high stresses. The minimum strain rate varies with stress according to an ap...
متن کاملEffects of Various Ageing Heat Treatments on Microstructural Features and Hardness of Piston Aluminum Alloy
Piston aluminum alloys have different intermetallic phases, such as Cu3Al, Mg2Si ,and AlNi phases. The morphology and the distribution of such phases have important roles on mechanical properties of the piston material. Therefore, in this research, various ageing heat treatments on the mentioned material were done and the microstructural feature and the hardness were studi...
متن کاملInfluence of Orientation and Radiative Heat Transfer on Aluminum Foams in Buoyancy-Induced Convection
Two differently-produced open-cell aluminum foams were compared to a commercially available finned heat sink. Further, an aluminum plate and block were tested as a reference. All heat sinks have the same base plate dimensions of four by six inches. The first foam was made by investment casting of a polyurethane preform and has a porosity of 0.946 and a pore density of 10 pores per linear inch. ...
متن کاملSimulation of Foaming and Deformation for Composite Aluminum Foams
In this study, at the first stage, the rupture criterion of bubbles wall in Aluminum metal foam liquid was investigated by using Lattice Boltzmann. The two phases modeling were accomplished by using a modified Shan-Chen model. This model was run for several bubbles in A356+3wt.%SiC melt system. Then, bubbles morphologies (virtual metallographic) for A356+3wt.%SiC foams were simulated. Results s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals
سال: 2012
ISSN: 2075-4701
DOI: 10.3390/met2040508