Application of Op-amp Fixators in Analog Circuits
نویسندگان
چکیده
منابع مشابه
Application of Op-amp Fixators in Analog Circuits
Nullor elements have applications not only in analog behaviour modeling but also in analog circuit design and analysis. Fixator-norator pair, the emerging tool in analog design is a combination of a nullor and sources. A method for the realization of fixator-norator pair is discussed in this paper. Application of fixator-norator pair into a circuit makes it possible to perform the AC and DC des...
متن کاملSingle Power Supply Op-Amp Circuits
Operational amplifiers have traditionally been operated using dual power supplies–often +15 volts and -15 volts. However, that is not a requirement. An op-amp will operate with any upper and lower power supply voltage provided the voltage across the amplifier is less than maximum ratings and voltages at the terminals are within the specification range relative to the power supply voltages. This...
متن کاملApplication Considerations and Circuits for a New Chopper-Stabilized Op Amp
L, LT, LTC, LTM, Linear Technology and the Linear logo are registered trademarks of Linear Technology Corporation. All other trademarks are the property of their respective owners. A great deal of progress has been made in op amp DC characteristics. Carefully executed designs currently available provide sub-microvolt VOS ΔT drift, low bias currents and open-loop gains exceeding one million. Con...
متن کاملApplication Note 71 Micropower Circuits Using the LM4250 Programmable Op Amp
The LM4250 is a highly versatile monolithic operational amplifier. A single external programming resistor determines the quiescent power dissipation, input offset and bias currents, slew rate, gain-bandwidth product, and input noise characteristics of the amplifier. Since the device is in effect a different op amp for each externally programmed set current, it is possible to use a single stock ...
متن کاملGeneration of Current Conveyor-Based All-Pass Filters from Op Amp-Based Circuits [Transaction Briefs - Circuits and Systems II: Analog and Digital Signal Processing, IEEE Transactions on
In this brief, it is shown that two of the recently reported voltage mode and current mode current conveyor-based all-pass circuits can be generated from the well known single input op amp all-pass configuration. It is also found that two other voltage mode current conveyor-based all-pass circuits are related directly to the differential input op amp all-pass structure. Several new grounded cap...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering and Technology
سال: 2016
ISSN: 2319-8613,0975-4024
DOI: 10.21817/ijet/2016/v8i5/160805411