Assessing Fresh Concrete Performance and Water Absorption Characteristics of Concrete with Partially Replaced Broken Tiles

نویسندگان

چکیده

A number of research seeking alternative materials to augment normal coarse aggregate reduce overreliance on granite while saving the environment is rise. This study assessed workability, water absorption and density concrete with waste ceramic tiles as partial replacement for crushed aggregate. Crushed from manufacturing industries construction sites were blended production. mix ratio 1: 1.11: 2.72 (cement: sand: coarse) nominal C30 was produced (0, 10, 20, 30, 40, 50 100) percent volume at constant water-cement 0.5 produce cubes cured 7 28 days. Tests conducted revealed workability decreased increasing increased but not above acceptable limits. However, use in encouraged, exceeding 20% maximum structural concrete. mode recycling could positively promote green sustained environment; hence, it should be encouraged conditional limitation further its use.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of sample conditioning on the water absorption of concrete

ASTM C1585 is commonly used to determine the absorption and rate of absorption of water in unsaturated hydraulic cement concretes. Unfortunately, a wide range of relative humidities can exist in the samples after this relatively short conditioning period and such variation may considerably influence the test results. Three main variables were studied in this program: the water to cement ratio, ...

متن کامل

Investigating the Performance Characteristics of Asphaltic Concrete Containing Nano-Silica

Using nano-technology materials in the asphalt pavement industry is new compared with Portland cement concrete. The main objective of this study is to investigate the effects of nano-silica modification on some properties of a penetration grade asphalt cement and a typical asphalt concrete. 60/70 penetration grade bitumen was modified with different percentages of nano-silica (i.e. 1, 3 and 5%,...

متن کامل

―Analysis Of The Strength And Durability Of The Concrete With Partially Replaced By The Ceramic Slurry Waste Powder‖

Ceramic waste is most commonly produce from ceramic industry, this waste is in the form of pest and hard form, pest waste is known as the filter waste or slurry waste, which is produced at the end of polishing and finishing of ceramic tiles. The paper discuss that ceramic slurry waste powder is replaced by cement in concrete. Concrete grade M25 was made by replacing by 0% to 30% of Ordinary Por...

متن کامل

Dynamic Shear Energy Absorption of Ultra-High Performance Concrete

The exemplary mechanical performance and durability of ultra-high performance concrete (UHPC) has led to its rapid emergence as an advanced cementitious material. The uncharacteristically high mechanical strength and ductility of UHPC makes it a promising potential material for defense structures which may be subject to highly dynamic loads like impact or blast. However, the mechanical response...

متن کامل

Performance of Continuously Reinforced Concrete Pavement Containing Recycled Concrete Aggregate

In 1995, the Texas Department of Transportation (TxDOT) began reconstruction in Houston on a section of IH-10 with continuously reinforced concrete pavement (CRCP). The unique aspect of this project was the use of crushed concrete as both coarse and fine aggregates in the new concrete. No virgin aggregates were used. The primary objectives of this study were to evaluate (1) the material propert...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Engineering Research and Reports

سال: 2022

ISSN: ['2582-2926']

DOI: https://doi.org/10.9734/jerr/2022/v23i12789