Assessment of vortex generator shapes and pin fin perforations for enhancing water-based heat sink performance
نویسندگان
چکیده
منابع مشابه
Thermal Performance of an Elliptical Pin Fin Heat Sink
Christopher L. Chapman, and Seri Lee Aavid Engineering, Inc. Laconia, New Hampshire 03247 Bill L. Schmidt Silicon Graphics Computer Systems Mountainview, California 94039 Comparative thermal tests have been carried out using aluminum heat sinks made with extruded fin, cross-cut rectangular pins, and elliptical shaped pins in low air flow environments. The elliptical pin heat sink was designed t...
متن کاملResearch on Properties of Fluid Pressure Drop for Electric Vehicle IGBT Pin Fin Heat Sink
The Performance of electric vehicle IGPT Pin fin heat sink can be measured by the temperature field and the fluid pressure and other parameters. In order to improve the cooling effect of Pin fin heat sink, diameter, length and distance of the fin was optimized combination. The relationship between pressure drop of the water inlet, outlet and pin fin parameters was analyzed and calculated. It wa...
متن کاملNumerical Optimization of Pin-Fin Heat Sink with Forced Cooling
This study presents the numerical simulation of optimum pin-fin heat sink with air impinging cooling by using Taguchi method. 9 L ( 4 3 ) orthogonal array is selected as a plan for the four design-parameters with three levels. The governing equations are discretized by using the control-volume-based-finite-difference method with a power-law scheme on the non-uniform staggered grid. We solved th...
متن کاملFlow boiling of water in a circular staggered micro-pin fin heat sink
Flow boiling of water across a bank of circular staggered micro-pin fins, 250 lm long and 100 lm diameter with pitch-to-diameter ratio of 1.5, was experimentally studied for mass fluxes ranging from 346 kg/m s to 794 kg/m s and surface heat fluxes ranging from 20 W/cm to 350 W/cm. Local temperature measurements were used to elucidate the two-phase heat transfer coefficients. The flow was visual...
متن کاملExperimental and Numerical Analysis of Built-In Thermoelectric Generator Modules with an Elliptical Pin-Fin Heat Sink
A three-dimensional numerical model of thermoelectric generator (TEG) modules attached to a large chimney plate is proposed and solved numerically using a control volume based finite difference formulation. The TEG module consists of a thermoelectric generator, an elliptical pin-fin heat sink, and a cold plate for water cooling. In the chimney, the temperature of flue gases is 450-650K. Althoug...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Communications in Heat and Mass Transfer
سال: 2018
ISSN: 0735-1933
DOI: 10.1016/j.icheatmasstransfer.2017.11.002