Austenite Reversion Tempering-Annealing of 4 wt.% Manganese Steels for Automotive Forging Application
نویسندگان
چکیده
منابع مشابه
Ultra-Fine Grained Dual-Phase Steels
This paper provides an overview on obtaining low-carbon ultra-fine grained dual-phase steels through rapid intercritical annealing of cold-rolled sheet as improved materials for automotive applications. A laboratory processing route was designed that involves cold-rolling of a tempered martensite structure followed by a second tempering step to produce a fine grained aggregate of ferrite and ca...
متن کاملG. (2014) Nanocharacterisation of precipitates in austenite high manganese steels with advanced techniques: HRSTEM and DualEELS
To achieve optimal mechanical properties in high manganese steels, the precipitation of nanoprecipitates of vanadium and niobium carbides is under investigation. It is shown that under controlled heat treatments between 850°C and 950°C following hot deformation, few-nanometre precipitates of either carbide can be produced in test steels with suitable contents of vanadium or niobium. The structu...
متن کاملAustenite formation during intercritical annealing
Purpose: of this paper is the effect of the soft annealing of initial microstructure of the 6Mn16 steel on the kinetics of the austenite formation during next intercritical annealing. Design/methodology/approach: Analytical TEM point analysis with EDAX system attached to Philips CM20 was used to evaluate the concentration of Mn, Ni and Cr in the microstructure constituents of the multiphase ste...
متن کاملTempering of hard mixture of bainitic ferrite and austenite
Recent work has shown that bainitic ferrite plates produced by transformation at low temperatures can be as thin as 20 nm with a hardness in excess of 650 HV30, tensile strengthy2.3 GPa and toughnessy30 MPa m. Because these properties rely on the fine scale of the microstructure, a study has been carried out in relation to the tempering resistance of steel over the temperature range 350 – 750uC...
متن کاملAnnealing and Tempering for Sampling and Counting
iii ACKNOWLEDGEMENTS I would like to thank my advisors Dana Randall and Eric Vigoda for their guidance and support, which they gave generously. I was fortunate to have the opportunity to work with two of the leading researchers in my field. Dana never ceased to surprise me with her quick insights and ability to get to crux of a problem. I thoroughly enjoyed working with Eric and am always inspi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals
سال: 2019
ISSN: 2075-4701
DOI: 10.3390/met9050575