Automatic Control of Arc Welding
نویسندگان
چکیده
منابع مشابه
Control of pulsed gas metal arc welding
This paper presents a control system for manual pulsed Gas Metal Arc Welding (GMAW). This system consists of a current controller, which makes it possible to shape the current during welding, and two important components, which are the key issues discussed in this paper. These components include an arc length controller and a metal transfer controller. The arc length controller is based on a no...
متن کاملDevelopment of an automatic arc welding system using an adaptive sliding mode control
This paper develops an automatic welding control scheme for alternating current shielded metal arc welding (SMAW) system. A mathematical model of the welding control system is derived and the system parameters identified. An adaptive sliding mode controller is designed to estimate the bound of the system uncertainties and to modulate the electrode feed rate in such a way that the desired arc le...
متن کاملGas tungsten arc welding
Gas tungsten arc welding (GTAW), also known as tungsten inert gas (TIG) welding, is an arc welding process that uses a nonconsumable tungsten electrode to produce the weld. The weld area is protected from atmospheric contamination by a shielding gas (usually an inert gas such as argon), and a filler metal is normally used, though some welds, known as autogenous welds, do not require it. A const...
متن کاملNonlinear interval model control of quasi-keyhole arc welding process
This paper addresses the development of a nonlinear model based interval model control system for the quasi-keyhole arc welding process, a novel arc welding process which has advantages over the laser welding process and conventional arc welding processes. The structure of the nonlinear model chosen was proposed based on an analysis of the quasi-keyhole process to be controlled. Because of the ...
متن کاملModeling and control of quasi-keyhole arc welding process
Quasi-keyhole is a novel approach proposed to operate the keyhole arc welding process. Because the method’s effectiveness depends on the amperage of the peak current used to establish the keyhole, this paper proposes adjusting the amperage based on the duration of the peak current, which equals the keyhole establishment time. A nominal model structure has been selected from those identified usi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1972
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.41.613