Automatic digitization of pluviograph strip charts
نویسندگان
چکیده
منابع مشابه
Automatic Detection of Solar Filaments Versus Manual Digitization
The technique which is presented here is based on careful attention to image cleaning in order to achieve robust automatic filament detection and avoid confusion between filaments and image defects, due to particular shapes of filaments. The main part of the detection process is based on seed selection and region growing. The procedures developed have been tested on four months of full-disk ima...
متن کاملLineLens: Automatic Data Extraction from Line Charts
INTRODUCTION Charts and Diagrams are used extensively in newspapers, scientific publications, and visualization websites to communicate data to the audience succinctly and compactly. These charts often contain useful and valuable information and cover a wide variety of topics. It would be advantageous for users to be able to directly search for and query on these charts, instead of sifting thro...
متن کاملAutomatic Load Test Verification Using Control Charts
Load testing is an important phase in the software development process. It is very time consuming but there is usually little time for it. As a solution to the tight testing schedule, software companies automate their testing procedures. However, existing automation only reduces the time required to run load tests. The analysis of the test results is still performed manually. A typical load tes...
متن کاملAutomatic Generation of Conformance Tests from Message Sequence Charts
Over the past five years our group has developed a tool that automatically generates conformance test scripts from a combination of Message Sequence Charts (MSCs), specifying dynamic behaviour, and Protocol Data Units (PDUs), specifying data formats. This paper outlines how tests are derived from MSCs and PDU specifications, and summarises different test strategies. It describes the testing req...
متن کاملAutomatic Calibration of Multi-strip Position-Sensitive Detector
Calibration is the transformation of the output channels of a measuring device into the physical values (energies, times, angles etc.) It is a laborand time-consuming task even if only few detectors are used. However, the situation changes appreciably if the calibration of a multi-detector system is required, where the number of registering devices extends for hundreds [1]. Let us have a look a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Meteorological Applications
سال: 2015
ISSN: 1350-4827
DOI: 10.1002/met.1522