Automatic Process for Manufacturing Free-form Surface by Electrical Discharge Machining.
نویسندگان
چکیده
منابع مشابه
Intelligent Knowledge Based System Approach for Optimization of Design and Manufacturing Process for Wire-Electrical Discharge Machining
Wire electrical discharge machining (WEDM) is a method to cut conductive materials with a thin electrode that follows a programmed path. The electrode is a thin wire. Typical diameters range from .004" - .012" (.10mm - .30mm) although smaller and larger diameters are available. WEDM is a thermal machining process capable of accurately machining parts with varying hardness or complex shapes. WED...
متن کاملIntelligent Knowledge Based System Approach for Optimization of Design and Manufacturing Process for Wire-Electrical Discharge Machining
Wire electrical discharge machining (WEDM) is a method to cut conductive materials with a thin electrode that follows a programmed path. The electrode is a thin wire. Typical diameters range from .004" - .012" (.10mm - .30mm) although smaller and larger diameters are available. WEDM is a thermal machining process capable of accurately machining parts with varying hardness or complex shapes. WED...
متن کاملExperimental Study on the Surface Modification by Electrical Discharge Process
The creation of modified layer on metal surfaces using new methods is one of the procedures in surface engineering which can improve the surface mechanical properties. The electrical discharge process is a new method that can form a modified layer on the metal surfaces. This study aims to improve of pure aluminum surface properties through Electrical Discharge process with Monel 400 electrode. ...
متن کاملMechanical Surface Treatments of Ti-6Al-4V Miniplate Implant Manufactured by Electrical Discharge Machining (TECHNICAL NOTE)
Present work aims at multi-mechanical surface treatment of Ti-6Al-4V based-miniplate implant manufactured by electrical discharge machining (EDM) for biomedical use. Mechanical surface treatment consists of consequent use of ultrasonic cleaning, rotary tumbler polishing, and brushing. Surface layers are analyzed employing scanning electron microscopy and energy dispersive X-ray spectroscopy. Al...
متن کاملModeling and Simulation of Micro Electrical Discharge Machining Process
ii ACKNOWLEDGEMENTS iv TABLE OF CONTENTS v LIST OF FIGURES ix LIST OF TABLES xiii CHAPTER
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1992
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.58.667