Autotuning of Parallel Cascade Control using Setpoint Relay
نویسندگان
چکیده
منابع مشابه
Autotuning of Parallel Cascade Control using Setpoint Relay
A new approach to tune the PI controller for parallel cascade control using setpoint relay autotuning method is proposed in this paper. The setpoint relay autotuning is found to be effective as that of the relay feedback method without switching off existing controller. The proposed method is found to be more advantageous for finding out ultimate gain and ultimate period and tested in computer ...
متن کاملRelay-Based Autotuning With Algebraic Control Design
In this paper, a combination of relay feedback identification and an algebraic control design method for stable systems is studied. Models with up to three parameters are estimated by means of a single asymmetrical relay experiment. Then a stable low order transfer function is identified. Then the controller is analytically derived from general solutions of Diophantine equations in the ring of ...
متن کاملRelay Auto Tuning Of Parallel Cascade Controller
The present work is concerned with relay auto tuning of parallel cascade controllers. The method proposed by Srinivasan and Chidambaram [10] to analyze the conventional on-off relay oscillations for a single loop feedback controller is extended to the relay tuning of parallel cascade controllers. Using the ultimate gain and ultimate cross over frequency of the two loops, the inner loop (PI) and...
متن کاملRelay Autotuning of Pid Controllers
The classical approach to the design of control systems is to use a mathematical model, typically in transfer function or state space form, of the process to be controlled. This model is usually obtained either from the physical equations of the process or by identification, namely an experiment to obtain process input and output operating data which is then analyzed to find a mathematical mode...
متن کاملExtensions and Modifications of Relay Autotuning
In this thesis extensions and modifications of Åström-Hägglund autotuning are investigated. A method where relay autotuning is extended to multi-input-multi-output control systems is suggested. The method is based on identification of n×n simple two-parameter transfer functions through n identification experiments. The method is experimentally tested on a water-mixer and a pilot-plant distillat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Computer Applications
سال: 2010
ISSN: 0975-8887
DOI: 10.5120/1540-143