Bar-Wave Calibration of Acoustic Emission Sensors
نویسندگان
چکیده
منابع مشابه
Bar-Wave Calibration of Acoustic Emission Sensors
This study extended a bar-wave calibration method for acoustic emission (AE) sensors. It combined laser interferometer displacement measurements and the wave propagation medium of a long bar, excited at its end with an ultrasonic transducer driven by a pulser. Receiving bar-wave sensitivities of 16 types of AE sensors were measured and compared to their receiving sensitivities to normally incid...
متن کاملCalibration Methods of Acoustic Emission Sensors
This study examined outstanding issues of sensitivity calibration methods for ultrasonic and acoustic emission transducers and provides workable solutions based on physically measureable quantities, laser-based displacement measurement in particular. This leads to mutually consistent determination of transmitting and receiving sensitivities of sensors and transducers. Methods of circumventing p...
متن کاملSensors - Acoustic Wave Technology Sensors
Acoustic wave devices have been in commercial use for more than 60 years. The telecommunications industry is the largest consumer, accounting for ~3 bil lion acoustic wave filters annually, primarily in mobile cell phones and base stations. These are typically surface acoustic wave (SAW) devices, and act as bandpass filters in both the radio frequency and intermediate frequency sections of the ...
متن کاملLead-free acoustic emission sensors.
Acoustic emission (AE) sensors have been fabricated using both soft- and hard-type lead-free (Na0.5K0.5)NbO3-based ceramics. The acoustic and electromechanical properties of the ceramics have been determined using the resonance technique. The lead-free AE sensors were calibrated using a laser source and compared to a commercial sensor. A lead zirconate titanate (PZT) 5H ceramics AE sensor has a...
متن کاملAcoustic Wave Hydrogen Gas Sensors
Amorphous titanium dioxide (TiO2) and gold (Au) doped TiO2-based surface acoustic wave (SAW) sensors have been investigated as hydrogen gas detectors. The nanocrystal-doped TiO2 films were synthesized through a sol-gel route, mixing a Ti-butoxide-based solution with diluted colloidal gold nanoparticles. The films were deposited via spin coating onto 64◦ YX LiNbO3 SAW transducers in a helium atm...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Sciences
سال: 2017
ISSN: 2076-3417
DOI: 10.3390/app7100964