Behavior of Concrete Deep Beam Reinforced with Inclined Web Reinforcement around Different Opening Shapes

Effect Of Web Reinforcement On Ultimate Strength Of Reinforced Concrete Deep Beam

It is observed that, reinforced concrete beams failed due to flexure but in case of deep beam failure occur due to shear. Deep beams may be defined as the beam where shear span to depth ratio less than 2. A number of researchers already proposed various approach to predict the ultimate strength of deep beams. In this study a newer approach is developed to calculate the ultimate shear strength o...

Behavior of Composite Timber-Concrete Beam with CFRP Reinforcement

Shear Strength of Slender Reinforced Concrete Beams without Web Reinforcement

This paper attempt to predict the shear strength of high strength concrete beam with different shear span of depth ratio without web reinforcement. The large data base available has been clustered and a linear equation analysis has been performed . The prepared models are functions of compressive strength , percentage of flexural reinforcement and depth of beam. The proposed models have been va...

Seismic Behavior of Steel Reinforced Concrete Beam-Columns and Frames

The ability to perform accurate nonlinear simulations is a key component in the assessment of the behavior of seismic force resisting systems. A three-dimensional distributed plasticity formulation for composite beam-columns suitable for nonlinear static and dynamic analyses of composite seismic force resisting systems has been developed. New uniaxial constitutive relations are developed for th...

Experimental and Analytical Study on Reinforced Concrete Deep Beam

ABSTRACT: Several reinforced concrete deep beams with different L/D ratios (1.5, 1.6, 1.71) were cast and tested in order to investigate the strain distribution pattern at mid-section of the beam. This paper describes analysis of deep beams subjected to two point loading with three different L/D ratios (1.5, 1.6, 1.71) using Non-linear Finite element method (ANSYS 9.0 software). In ANSYS 9.0 so...