Behavior of synchronous motors during starting
نویسندگان
چکیده
منابع مشابه
INDUCTION MOTORS - PROTECTION and STARTING
It is well understood that induction motors draw higher currents during their starting operations than is the case under full load running conditions. Since the early days of induction motor availability, starting methods other than Direct-on-Line have been used, and in some cases mandated by Utilities, to reduce the effect of these high starting currents on the electrical distribution network....
متن کاملDynamic Model of Pm Synchronous Motors
In a permanent magnet synchronous motor where inductances vary as a function of rotor angle, the 2 phase (d-q) equivalent circuit model is commonly used for simplicity and intuition. In this article, a two phase model for a PM synchronous motor is derived and the properties of the circuits and variables are discussed in relation to the physical 3 phase entities. Moreover, the paper suggests met...
متن کاملDigital Control of Permanent Magnet Synchronous Motors
Permanent Magnet Synchronous Motor (PMSM) variable-speed drive is widely used in the industry because of its particularly high mechanical power density, simplicity and cost effectiveness. Eliminating the mechanical sensor mounted on the shaft of the motors gives further improvement. These drives are referred to as “sensorless” electrical drives. In this paper a novel sensorless algorithm is pro...
متن کاملNonlinear Model of Permanent-Magnet Synchronous Motors
Jun-qiang Lian, Shun-yi Xie , Wang Jian,Ping Hu Department of Weaponry Engineering., Naval University of Engineering, Wuhan 430033, China [email protected] Department of Weaponry Engineering., Naval University of Engineering, Wuhan 430033, China Higher Education Research Units., Naval University of Engineering, Wuhan 430033, China Department of Weaponry Engineering., Naval University of Engineer...
متن کاملOptimum Design Parameters for Synchronous Reluctance Motors
A series of synchronous reluctance motors (RSM) are analysed using finite element methods. The amount of iron in each rotor is kept the same. It is shown that the saliency ratio is not only dependent on the flux guide reluctance factor but also on the position or span of flux guides. It is also shown that an axially laminated design may not be an optimum configuration due to large number of flu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Proceedings of the American Institute of Electrical Engineers
سال: 1913
ISSN: 0097-2444
DOI: 10.1109/paiee.1913.6660744