Bend-insensitive lasing characteristics of singlemode, large-mode-area Ytterbium-doped photonic crystal fiber
نویسندگان
چکیده
منابع مشابه
Large-mode-area single-mode-output Neodymium-doped silicate glass all-solid photonic crystal fiber
We have demonstrated a 45 μm core diameter Neodymium-doped all-solid silicate glass photonic crystal fiber laser with a single mode laser output. The structure parameters and modes information of the fiber are both demonstrated by theoretical calculations using Finite Difference Time Domain (FDTD) method and experimental measurements. Maximum 0.8 W output power limited by launched pump power ha...
متن کاملLarge mode area Yb - doped photonic bandgap fiber lasers
Large mode area Yb-doped photonic bandgap fiber lasers Report Title Fiber lasers are in the process of revolutionizing modern manufacturing. Further power scaling is still much desired to increase throughput and to break new frontiers in science and defense. It has become very clear now that highly single-mode fibers with large effective mode areas are required to overcome both nonlinear effect...
متن کاملLasing in thulium-doped polarizing photonic crystal fiber.
We describe lasing of a thulium-doped polarizing photonic crystal fiber. A 4 m long fiber with 50 μm diameter core, 250 μm diameter cladding, and d/Λ ratio of 0.18 was pumped with a 793 nm diode and produced a polarized output with a polarization extinction ratio (PER) of 15 dB and an M(2) of <1.15. An intracavity polarizer and half-wave plate minimally increased the PER to 16 dB. The output po...
متن کاملPhosphate ytterbium-doped single-mode all-solid photonic crystal fiber with output power of 13.8 W
Single-mode ytterbium-doped phosphate all-solid photonic crystal fiber (AS-PCF) with 13.8 W output power and 32% slope efficiency was reported. By altering the diameter of the rods around the doped core and thus breaking the symmetry of the fiber, a polarization-maintaining AS-PCF with degree of polarization of >85% was also achieved, for the first time to knowledge, in a phosphate PCF.
متن کاملLow-loss singlemode large mode area all-silica photonic bandgap fiber.
We describe the design and characterization of solid core large mode area bandgap fibers exhibiting low propagation loss and low bend loss. The fibers have been prepared by modified chemical vapor deposition process. The bandgap guidance obtained thanks to a 3-bilayer periodic cladding is assisted by a very slight index step (5.10-4) in the solid core. The propagation loss reaches a few dB/km a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2008
ISSN: 1094-4087
DOI: 10.1364/oe.16.000579