Bending of Alloy Steel Pipes and Copper Alloy Pipes by High Frequency Induction Heating Method
نویسندگان
چکیده
منابع مشابه
Health Monitoring of Welded Steel Pipes by Vibration Analysis
In the present work, structure health monitoring (SHM) of welded steel pipes was used to diagnosis their state via vibration based damage detection techniques. The dynamic quantities such as Frequency Response Functions (FRFs), mode shapes and modal parameters from structural vibration to detect damage were measured, set on linear averaging mode, with a maximum frequency of analysis of 3.2 kHz....
متن کاملPipes under Internal Pressure and Bending
This article covers the general behaviour of a straight uniform pipe, with built-in open ends, subject to internal pressure and in plane bending or curvature. It is intended as a summary of the basic equations driving the unintuitive phenomena of bending and instability of pipes under internal pressure. The analysis covers in addition the investigation of opposite pressure stabilisation effects...
متن کاملThroughput for Steel Pipes Manufacturing Process Design
To increase productivity, new automatic production lines are introduced driven by adequate computer hardware and software. While determining production process characteristics for building complex product such as steel vessel, special consideration is given to dimensioning and defining capacity of production equipment and working places. Process characteristics should accomplish building and ou...
متن کاملAir cooled bainitic steels for strong, seamless pipes Part 1 – alloy design, kinetics and microstructure
Seamless pipes are usually quenched and tempered after manufacture in order to obtain the desired properties. The possibility of avoiding this heat treatment is explored here, by designing steels which transform into an carbide free bainitic microstructure during cooling from the hot processing phase of the pipe. The cooling conditions studied are appropriate for the manufacturing process and c...
متن کاملNumerical and Experimental Investigations on Springback of U-bending of DP600 Steel Alloy Sheet
The most prominent feature of sheet material forming process is an elastic recovery phenomenon during unloading which leads to springback and side wall curl. Therefore evaluation of springback and side wall curl is mandatory for production of precise products. In this paper, the effects of some parameters such as friction coefficient, sheet thickness, yield strength of sheet and blank-holder fo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Naval Architects of Japan
سال: 1968
ISSN: 1884-2070,0514-8499
DOI: 10.2534/jjasnaoe1968.1968.124_375