Bending of Wide Thick Mild Steel Plate (the 3rd report)
نویسندگان
چکیده
منابع مشابه
TOPOLOGY OPTIMIZATION OF PERFORATED STEEL PLATE SHEAR WALLS WITH THICK PLATE IN SIMPLE FRAMES
In this paper, topology optimization (TO) is applied to determine the form, size and location of holes for the special form of perforated steel plate shear wall (PSPSW). The proposed model is based on the recently presented particular form of PSPSW that is called the ring-shaped steel plate shear wall. The strain energy is selected as the objective function in the optimization. Simple Isotropic...
متن کاملThe mechanical and thick section bending behavior of friction stir processed aluminum plate
Friction stir processing (FSP) 2519-T87 aluminum plate results in enhanced ductility, 25% strain at fracture. However, the yield strength in the FSP zone drops to 175 MPa from �400 MPa. Actively cooling the plate during FSP increases the yield strength to 185 MPa and decreases ductility to 20% strain at fracture. Thick bending of a plate of the alloy was demonstrated after the surface was subje...
متن کاملnonlinear bending analysis of thick functionally graded plates based on third-order shear deformation plate theory
in this paper the nonlinear bending analysis of thick functionally graded plates subjected to mechanical loading is studied. the formulation is derived based on the third-order shear deformation plate theory and von kármán type non-linearity. young’s modulus is assumed to vary according to a power law distribution in terms of the volume fractions of the constituents. the principle of virtual wo...
متن کاملMicrostructure and Mechanical Properties of Narrow Gap Laser-Arc Hybrid Welded 40 mm Thick Mild Steel
Both laser-arc hybrid welding and narrow gap welding have potential for the fabrication of thick sections, but their combination has been seldom studied. In this research, 40 mm thick mild steel was welded by narrow gap laser-arc hybrid welding. A weld with smooth layer transition, free of visible defects, was obtained by nine passes at a 6 mm width narrow gap. The lower part of the weld has th...
متن کاملNumerical Simulation of Middle Thick Plate in the U-Shaped Bending Spring Back and the Change of Thickness
In this paper, the typical U-shaped pieces were taken as the object of study and the finite element numerical simulation software Dynaform is applied to simulate the effect of sheet metal bending. The U-shaped bending spring back and its thickness change are analyzed. The influence law of main parameters of die structure to sheet thickness change and the spring back amount are obtained by combi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Naval Architects of Japan
سال: 1975
ISSN: 1884-2070,0514-8499
DOI: 10.2534/jjasnaoe1968.1975.341