BGA Height Measurement Using Pattern Beam

Altitude measurement using laser beam reflected from water surface

In this paper altitude measurement from water surface using laser beam is presented. Research data indicate that the reflection of infrared waves from water surface is about zero and it is less than 2% for visible radiations. Phase-shift and heterodyne technique was used for the measurement, and the laser beam ( mW p nm 10 , 700 = = l ) was modulated by a sine wave having a fixed frequency....

Vibrational power flow measurement in a beam using electronic speckle pattern interferometry

Measurement of Thermally Induced Warpage of BGA Packages/Substrates Using Phase-Stepping Shadow Moiré

Phase-stepping technique is applied to the analysis of fringe pattern images of BGAs (Ball Grid Arrays) obtained by shadow moiré. Sensitivity of the fringe pattern analysis is demonstrated to be significantly increased. Thermally induced warpage of BGAs is successfully measured in real-time as the sample is driven through a simulated reflow process. The paper discusses the technique of phase st...

Stature estimation using the knee height measurement amongst Brazilian elderly.

INTRODUCTION Stature is an important variable in several indices of nutritional status that are applicable to elderly persons. However, stature is difficult or impossible to measure in elderly because they are often unable to maintain the standing position. A alternative is the use of estimated height from measurements of knee height measure. AIMS This study aimed to evaluate the accuracy of ...

Stereoscopic roadside curb height measurement using V-disparity

Managing road assets, such as roadside curbs, is one of the interests of municipalities. As an interesting application of computer vision, this paper proposes a system for automated measurement of the height of the roadside curbs. The developed system uses the spatial information available in the disparity image obtained from a stereo setup. Data about the geometry of the scene is extracted in ...