Bidirectional Flyback-push-pull Dc-dc Converter
نویسندگان
چکیده
منابع مشابه
A Three-Phase Current-Fed Push–Pull DC–DC Converter
In this paper, a new three-phase current-fed push– pull dc–dc converter is proposed. This converter uses a highfrequency three-phase transformer that provides galvanic isolation between the power source and the load. The three active switches are connected to the same reference, which simplifies the gate drive circuitry. Reduction of the input current ripple and the output voltage ripple is ach...
متن کاملA novel resonant transition push–pull DC-DC converter
In hard-switched converters, the switching frequency is limited by switching losses and EMI problems. However, high-switching frequency is necessary to reduce the converter size. Hence, soft switching is imperative at high switching frequency to obtain good efficiency. Push–pull converter is a preferred topology at medium power level. This paper proposes a novel resonant transition topology for...
متن کاملIsolated Switched Boost Push Pull DC-DC Step-up Converter
An isolated switched high step up boost DC-DC converter is discussed in this paper. The main objective of this paper is to step up low voltage to very high voltage. This paper mainly initiates at boosting a 30V DC into 240V DC. The discussed converter benefits from the continuous input current. Usually, step-up DC-DC converters are suitable for input whose voltage level is very low. The circuit...
متن کاملComparison of an Isolated bidirectional Dc-Dc converter with and without a Flyback Snubber
Renewable energy sources like solar and fuel cells are emerging as a promising supplementary power sources due to their merits of cleanness, high efficiency, and high reliability. But the output levels of these are low. An isolated bidirectional full-bridge dc–dc converter can be used for interfacing battery to the system. Because of the presence of leakage inductance of the isolation transform...
متن کاملA New Soft Switching Flyback-forward Pwm Dc-dc Converter
This paper presents a new soft switching flyback-forward PWM converter. The proposed circuit employs an auxiliary circuit to achieve soft switching condition for switches and also absorbs the voltage spikes caused by the leakage inductance of transformers in the converter. In the proposed converter main switch operates at ZVS and the auxiliary switch operates at ZCS. The proposed converter has ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Eletrônica de Potência
سال: 2015
ISSN: 1414-8862,1984-557X
DOI: 10.18618/rep.2015.2.195204