Biofunctionalization of PDMS-based microfluidic systems
نویسندگان
چکیده
منابع مشابه
Adhesive-based bonding technique for PDMS microfluidic devices.
We present a simple and inexpensive technique for bonding PDMS microfluidic devices. The technique uses only adhesive tape and an oven; plasma bonders and cleanroom facilities are not required. It also produces channels that are immediately hydrophobic, allowing formation of aqueous-in-oil emulsions.
متن کاملA PDMS-Based Cylindrical Hybrid Lens for Enhanced Fluorescence Detection in Microfluidic Systems
Microfluidic systems based on fluorescence detection have been developed and applied for many biological and chemical applications. Because of the tiny amount of sample in the system; the induced fluorescence can be weak. Therefore, most microfluidic systems deploy multiple optical components or sophisticated equipment to enhance the efficiency of fluorescence detection. However, these strategi...
متن کاملFunctionalized glass coating for PDMS microfluidic devices
Microfluidic devices can perform multiple laboratory functions on a single, compact, and fully integrated chip. However, fabrication of microfluidic devices is difficult, and current methods, such as glass-etching or soft-lithography in PDMS, are either expensive or yield devices with poor chemical robustness. We introduce a simple method that combines the simple fabrication of PDMS with superi...
متن کاملPdms Microfluidic Devices with Ptfe Passivated Channels
PDMS microfluidic devices whose whole inner surfaces are covered with PTFE (polytetrafluoroethylene) are described. The major problems of PDMS fluidic devices in practical use, are surface degradation with organic solvents and unexpected absorption of chemical materials. In order to overcome these problems, spin/dip-coated perfluoro amorphous polymer is used to form the passivation PTFE layer o...
متن کاملRapid fabrication of microfluidic PDMS devices from reusable PDMS molds using laser ablation
The conventional fabrication methods for microfluidic devices require cleanroom processes that are costly and time-consuming. We present a novel, facile, and low-cost method for rapid fabrication of polydimethylsiloxane (PDMS) molds and devices. The method consists of three main fabrication steps: female mold (FM), male mold (MM), and chip fabrication. We use a CO2 laser cutter to pattern a thi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Protocol Exchange
سال: 2011
ISSN: 2043-0116
DOI: 10.1038/protex.2011.271