Boiling heat transfer in unwetted heating surfaces. Effect of forced convection.
نویسندگان
چکیده
منابع مشابه
Heat Transfer Study of Perforated Fin under Forced Convection
Fins are protrusions on a heat transfer surface to augment heat transfer rate from it. The increase in area exposed to convection in case of finned surfaces results in increased heat transfer rate. In this study heat transfer characteristics of a pin fin with perforation is numerically analyzed. A pin fin is fabricated and experiments are done under forced convection conditions. The experimenta...
متن کاملAnalysis of variance of nanofluid heat transfer data for forced convection in horizontal spirally coiled tubes
In the present study, an experimental study is carried out to investigate the effect of adding Al and Cu nanoparticles to the base fluid (water) on the heat transfer rate in a spirally coiled tube. The spirally coiled tube is fabricated from the straight copper tube with the inner and outer coil diameters of 100 and 420 mm, respectively. The experiments have been done for water and two types of...
متن کاملForced Convection Subcooled Boiling of Binary Mixtures
A mode based on an additive mechanism of heat transfer is proposed for forced convection subcooled boiling of binary mixtures. The contributing modes of heat transfer are: (i) the heat transferred as latent heat by the rising bubbles, (ii) the heat transferred as the heat contained in the superheated thermal layer that is removed from the surface in the wake of the rising bubbles and (iii) the ...
متن کاملForced Convection Heat Transfer of Giesekus Viscoelastic Fluid in Concentric Annulus with both Cylinders Rotation
A theoretical solution is presented for the forced convection heat transfer of a viscoelastic fluid obeying the Giesekus constitutive equation in a concentric annulus under steady state, laminar, and purely tangential flow. A relative rotational motion exists between the inner and the outer cylinders, which induces the flow. A constant temperature was set in both cylinders, in this study. The f...
متن کاملForced-convection boiling and critical heat flux from a linear array of discrete heat sources
Forced-convection boiling experiments were performed with FC-72, a 3M Fluorinert, at 1.36 bar on a linear array of nine discrete heat sources simulating microelectronic chips, which were flushmounted in a vertical. rectangular channel. The inlet velocity and liquid subcooling were varied from 13 to 400 cm s’ and 3 to 36”C, respectively. Special design of the experimental apparatus allowed each ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1989
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.55.770