Bond nature between reinforcing phase and matrix in cast composite material of Al – FeCr system and reinforcement mechanism of cast Al-alloys obtained using Lost-foam casting process
نویسندگان
چکیده
منابع مشابه
THERMAL FATIGUE RESISTANCES OF 356 AND 413 CAST Al ALLOYS
Abstract: Thermal fatigue is a stochastic process often showing considerable scatter even in controlled environments. Due to complexity of thermal fatigue, there is no a complete analytical solution for predicting the effect of this property on the life of various components, subjected to severe thermal fluctuations. Among these components, one can mention car cylinder, cylinder head and pi...
متن کاملCreep Behavior of Al-Si Die-Cast Alloys
Commercial, aluminum die-cast alloys are subject to long-term stresses leading to viscoelastic material responses resulting in inefficient engine operation and failure. Constant load creep tests were conducted on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys. Rupture occurred in the primary creep regime, with the eutectic alloy having the longest times to failure. Pr...
متن کاملThe Effects of Gating Systems on the Soundness of Lost Foam Casting (LFC) Process of Al-Si Alloy (A.413.0)
The effects of gating systems, number of runner, and their locations, in the Lost Foam Casting (LFC) of Aluminum alloy (A.413.0) were investigated. Six different gating systems, with one or two running systems were designed. X-ray radiography and the three axis-bending tests have been employed to evaluate the casting soundness and quality. The results revealed that gating systems have a major e...
متن کاملPLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملCreep resistance of cast and aged Al–0.1Zr and Al–0.1Zr–0.1Ti (at.%) alloys at 300–400 C
Cast and aged Al–0.1Zr and Al–0.1Zr–0.1Ti (at.%) alloys, upon compressive creep deformation at 300–400 C, exhibit threshold stresses attributable to climb-controlled bypass of coherent Al3Zr and Al3(Zr1 xTix) precipitates. Al–0.1Zr–0.1Ti exhibits a smaller threshold stress than Al–0.1Zr, which is attributed principally to a reduced lattice parameter mismatch between the Al3(Zr1 xTix) precipitat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metall i lit?e Ukrainy
سال: 2022
ISSN: ['2077-1304', '2706-5529']
DOI: https://doi.org/10.15407/steelcast2022.04.036