CALCULATION METHOD OF FLEXURAL CRACK WIDTH OF REINFORCED CONCRETE MEMBER UNDER SUSTAINED LOADING
نویسندگان
چکیده
منابع مشابه
Time-Dependent Behavior of Reinforced Concrete Beams under Sustained and Repeated Loading
Abstract—The current study aims to highlight the loading characteristics impact on the time evolution (focusing particularly on long term effects) of the deformation of realized reinforced concrete beams. Namely the tension stiffening code provisions (i.e. within Eurocode 2) are reviewed with a clear intention to reassess their operational value and predicting capacity. In what follows the expe...
متن کاملCrack Growth and Lifetime of Concrete under Long Time Loading
Edge-notched eccentrically compressed fracture specimens made of aggregate of reduced size are loaded in standard creep test frames. Measurements of the time rate of crack mouth opening in notched concrete specimens subjected to constant load of almost one month duration are reported and analyzed. To reveal the size effect, geometrically similar specimens of four sizes in the ratio I :2:4:8 are...
متن کاملBehaviour of Reinforced Fibrous Concrete Beams under Reversed Cyclic Loading
When earthquakes occur, energy released by the earthquake gets induced into the structure as ground motion and this energy has to be dissipated for safety reasons. To release seismic energy, the structure should damage in such a way that on one hand, collapse of structure should not occur and on the other hand, after the earthquake, damage should be economically feasible to repair. To avoid the...
متن کاملPrediction of Crack Initiation Direction for Inclined Crack Under Biaxial Loading by Finite Element Method
This paper presents a simple method based on strain energy density criterion to study the crack initiation angle by finite element method under biaxial loading condition. The crack surface relative displacement method is used to eliminate the calculation of the stress intensity factors which are normally required. The analysis is performed using higher order four node quadrilateral element. The...
متن کاملprediction method of drying shrinkage crack in reinforced concrete walls
because thin plate reinforced concrete members such as walls and slabs are greatly influenced by the drying shrinkage, cracks can occur in these members due to the restraint of the volume change caused by drying shrinkage. therefore, the control of cracking due to drying shrinkage is very important in building construction that the thin plate members are frequently used. however, few researches...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)
سال: 2003
ISSN: 1340-4202,1881-8153
DOI: 10.3130/aijs.68.103_2