Calibration of Methods for Designing Large-Diameter Bored Piles: Serviceability limit state
نویسندگان
چکیده
منابع مشابه
Interpreting Strain Measurements from Load Tests in Bored Piles
In static load tests vibrating wire strain gages are generally used. The advantage of vibrating wire sensors over more conventional electrical resistance or semi-conductor types lies mainly in the sensor output, which is a frequency rather than a voltage or resistance. The frequency output is easier to transmit over long cables and is unaffected by voltage drops such as those which can be broug...
متن کاملServiceability limit state of vibrations in under-deck cable-stayed bridges accounting for vehicle-structure interaction
Verification of the serviceability limit state of vibrations due to traffic live loads can be neglected in conventional types of concrete road bridges but becomes critical in the design of slender structures like Under-Deck CableStayed bridges. The novelty of the work presented in this article is that an innovative vehicle-bridge interaction model is employed, in which realistic wheel dimension...
متن کاملReliability Index for Serviceability Limit State of Drilled Shafts under Undrained Compression
In recent years, reliability-based design (RBD) has gradually gained popularity in geotechnical engineering. Several RBD codes have been developed and implemented around the world that calibrate ultimate limit state (ULS) designs for a target ULS reliability index (βuls). However, the serviceability limit state (SLS) design still is considered using conventional deterministic approaches with an...
متن کاملPrediction of End Bearing Capacity for Pre-Bored Steel Pipe Piles Using Instrumented Spt Rods
The standard penetration test (SPT) has been widely used because of its usability, economy, and many correlations with soil properties among other factors. In SPT, hammer energy is an important factor to evaluate and calibrate N values. To measure hammer energy, an instrumented SPT rod was developed considering that stress waves transferring on rods during SPT driving are the same as stress wav...
متن کاملLateral Load Tests on Small-Diameter Piles for Slope Remediation
Slope reinforcement and the use of structural pile elements can be an effective slope remediation alternative when conventional remediation practices (e.g., improved drainage) fail to consider the causal factors leading to slope instability (e.g., strength loss due to weathering). An experimental research program was aimed at developing a rapid, cost-effective, and simple remediation system tha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Soils and Foundations
سال: 2009
ISSN: 0038-0806
DOI: 10.3208/sandf.49.897