Ceramic cutting tool.
نویسندگان
چکیده
منابع مشابه
Precision Cutting of Structured Ceramic Molds with Micro PCD Milling Tool
In order to machine micro structured dies and molds made of ceramics, micro milling tools made of poly-crystalline diamond (PCD) are developed. Many cutting edges are ground with diamond wheels. Tool wears of the PCD milling tool are evaluated by cutting spherical molds made of binder-less tungsten carbide and structured surfaces are machined for trial. From the experiments, it is clarified tha...
متن کاملCutting-Tool Materials and Cutting Fluids
The reasons for the availability of a large variety of cutting-tool materials is best appreciated by reviewing the top eight parameters in the first column in Table 22.2 on p. 638. Among various factors, the type of workpiece material machined, the type of operation, and the surface finish and dimensional accuracy required all affect the choice of a cutting-tool material. For example, for inter...
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملResearch on Cutting Performance of Ceramic Cutting Tools in Milling High Density Fiberboard
The effect of cutting parameters and tool parameters on cutting forces and tool wear were investigated in high density fiberboard (HDF) peripheral up-milling using toughened ceramic cutting tools. The results showed that whether at low speed cutting or high speed cutting, the tangential forces Ft and normal forces Fr increased slowly with the increase of cutting length. The tangential forces Ft...
متن کاملA Comparative Study of Tool Life Between Ceramic and CBN Cutting Tools when Machining 52100 Steel and Optimization of Cutting Parameters
This paper describes a comparison of tool life between ceramics and cubic boron nitride (CBN) cutting tools when machining hardened steels using the Taguchi method. An orthogonal design, signal-to-noise ratio (S/N) and analysis of variance (ANOVA) were employed to determine the effective cutting parameters on the tool life. The results indicated that the V was found to be a dominant factor on t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1986
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.52.1516