Changes in Mechanical Properties of Rocks Exposed to Alternate Dry and Wet Conditions.

determination of some physical and mechanical properties red bean

چکیده: در این تحقیق، برخی خواص فیزیکی و مکانیکی لوبیا قرمز به-صورت تابعی از محتوی رطوبت بررسی شد. نتایج نشان داد که رطوبت بر خواص فیزیکی لوبیا قرمز شامل طول، عرض، ضخامت، قطر متوسط هندسی، قطر متوسط حسابی، سطح تصویر شده، حجم، چگالی توده، تخلخل، وزن هزار دانه و زاویه ی استقرار استاتیکی در سطح احتمال 1 درصد اثر معنی داری دارد. به طوری که با افزایش رطوبت از 54/7 به 12 درصد بر پایه خشک طول، عرض، ضخام...

Mechanical Properties of Some Dental Resins in Wet and Dry Conditions

The objective of this paper was to review the acrylic based resins biodegradation phenomena. The general objectives are based on multidisciplinary research of biomaterials used in dental medicine. For this analysis, different types of polymers were evaluated for water absorption and mechanical strength degradation caused by exposure to saliva. Two sets of 10 specimens were prepared from the ana...

A New Experimental Method for in Situ Corrosion Monitoring Under Alternate Wet-Dry Conditions

A new experimental method was applied in in situ corrosion monitoring of mild steel Q235 under alternate wet-dry conditions. The thickness of the electrolyte film during the wet cycle was monitored by a high-precision balance with a sensibility of 0.1 mg. At the same time, an electrochemical impedance technique was employed to study the effect of film thickness on corrosion rates. Experimental ...

Monitoring wet and dry process using precipitation changes

Mechanical behavior of transparent nanofibrillar cellulose-chitosan nanocomposite films in dry and wet conditions.

Transparent, biocompatible and biodegradable chitosan (CS) nanocomposite films reinforced with nanofibrillar cellulose (NFC) were prepared by solution casting. The effects of NFC content on the mechanical properties in dry and wet conditions were investigated. The incorporation of NFC significantly enhanced the mechanical properties, especially in wet conditions. The ultimate tensile strength a...