Characteristic Scales of Wear Track Profiles Generated by Pin-on-Disk Wear Tests
نویسندگان
چکیده
منابع مشابه
Dry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning
Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...
متن کاملWear behaviour of martensitic NiTi shape memory alloy under ball-on-disk sliding tests
Ball-on-disk sliding wear tests were conducted on martensitic NiTi shape memory alloy against an alumina counter ball. The wear features and coefficients of friction of the samples subjected to different loads and sliding cycles were investigated to reveal the degradation process of the NiTi surface. Three stages of degradation were identified, namely, a near-zero wear stage, a transition wear ...
متن کاملDry and Wet Wear Characteristic of TiO2 Thin Film Prepared by Magnetic Sputtering in Ringer Solution
In this research, a thin film of TiO2 was applied on AZ91D using the method of magnetic sputtering. Microstructure investigations were done using field emission scanning electron microscope (FESEM) and X-ray diffraction (XRD). Wear resistance for the coating was investigated using the pin on the disk in the form of dry and in the Ringer's solution. After this test, the worn surface of the sampl...
متن کاملWear and Wear Debris Generated from Ceramic-on-Carbon Fibre Reinforced PEEK Hip Replacements
INTRODUCTION Concerns regarding UHMWPE wear particle induced osteolysis [1] have led to investigations of alternative bearing materials. Carbon-fibre reinforced poly-ether-ether-ketone (CFR-PEEK) has been shown in animal studies to have a similar biological activity to UHMWPE [2], whilst hip and knee configurations incorporating this polymer display reduced wear rates when compared with convent...
متن کاملDry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning
Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tribology Online
سال: 2008
ISSN: 1881-2198
DOI: 10.2474/trol.3.205