Characteristics of Heat Exchanger with Condensing

نویسندگان

چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The Overall Heat Transfer Characteristics of a Double Pipe Heat Exchanger: Comparison of Experimental Data with Predictions of Standard Correlations

The single-phase flow and thermal performance of a double pipe heat exchanger are examined by experimental methods. The working fluid is water at atmospheric pressure. Temperature measurements at the inlet and outlet of the two streams and also at an intermediate point half way between the inlet and outlet is made, using copper-constantan thermocouple wires. Mass flow rates for each stream are ...

متن کامل

Heat Transfer Characteristics in a Heat Exchanger for Turbulent Pulsating Water Flow with Different Amplitudes

The effect of pulsation on the heat transfer rates, for turbulent water stream with upstream pulsation of different amplitudes, in a double-pipe heat exchanger for both parallel and counter flows, with cold water on the shell side, was investigated. Pulsation frequencies, with using a reciprocating device, ranged up to 260 cycles per minute (up to 4.3 Hz) and 5 different displacement amplitudes...

متن کامل

Review Heat Exchanger: Research Development of Self-rotating Inserts in Heat Exchanger Tubes

Heat exchangers are widely used in power engineering and industrial applications, many techniques such as coiled tube, surface tension devices, rough surfaces, extended surfaces have been investigated to enhancethermal performance and to minimize the cost and size of the heat exchanger equipment. One of the most important techniques is tube insert. In general,tube inserts can be classified into...

متن کامل

a new approach to aim maximum heat recovery in plate-fin heat exchanger with constant heat transfer characteristics

the purpos of this paper is to aim the maximum heat transfer rate in a plate-fin heat exchanger with a constant volume and a contant surface area at a prescribed pressure drop. this paper propose a method for design a plat-fin heat exchanger in which a maximum pressure drop occurs at a constant volume and surface are. in this paper as a case study, a preheater of a gas turbine which is a plate-...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Transactions of the Society of Instrument and Control Engineers

سال: 1978

ISSN: 0453-4654

DOI: 10.9746/sicetr1965.14.467