Characteristics of SKD11 by Complex Process of Electrical Discharge Machining Using Liquid Suspended with Alumina Powder
نویسندگان
چکیده
منابع مشابه
Accuracy improvement in nanographite powder-suspended dielectric fluid for micro-electrical discharge machining processes
Micro-electric discharge machining (μ-EDM) is an important manufacturing process that is able to produce components and tools with micro-features. Improvement to this process has resulted in the use of powder mixed dielectric (PMD), which results in better surface quality and faster machining time. However, the presence of conductive powder in the dielectric fluid negatively affects the accurac...
متن کاملFatigue Life of Graphite Powder Mixing Electrical Discharge Machining AISI D2 Tool Steel
The present paper deals with the design of experimental work matrices for two groups of experiments by using Response surface methodology (RSM). The first EDM group was dealt with the use of kerosene dielectric alone, while the second was treated by adding the graphite micro powders mixing to dielectric fluid (PMEDM). The total heat flux generated and fatigue lives after EDM and PMEDM models we...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملModeling and Simulation of Micro Electrical Discharge Machining Process
ii ACKNOWLEDGEMENTS iv TABLE OF CONTENTS v LIST OF FIGURES ix LIST OF TABLES xiii CHAPTER
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1994
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.58.9_1067