Characteristics of the turbulent flow field in a wall attachment device. Effect of splitter distance, control flow rate and supply flow rate.
نویسندگان
چکیده
منابع مشابه
effect of sub-grid scales on large eddy simulation of particle deposition in a turbulent channel flow
چکیده ندارد.
15 صفحه اول: the effect of sericin levels (silk glue protein) on rate of in vitro maturation, fertilization and culture of sheep oocytes
هدف از آزمایش اول بررسی اثر سطوح مختلف سریسین [0 (control), 0.1, 0.5, 1.0, 2.5 %] افزوده شده به محیط , ivm بر cumulus cell expansion، بلوغ هسته و توسعه متوالی جنین، در گوسفندان نژاد سنجابی در فصل تولید مثلی می باشد. از سرگیری میوز به وسیله خارج شدن اولین پولار بادی اندازه گیری و هم چنین درصد رسیدن جنین های دو سلولی به مرحله کلیواژ و بلاستوسیت نیز به عنوان نشانه ای از میزان شایستگی توسعه اولیه ج...
the effects of changing roughness on the flow structure in the bends
flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...
Simulation and investigation of the effect of oil flow rate, electric signal of flow control valve and controller on the performance of a wet clutch
The using of wet clutches and hydraulic control devices causes a smoothly torque transfer. In this study, a wet clutch was simulated in Simulink MATLAB software. Firstly the mechanical section of the clutch was modeled and then the hydraulic section was simulated with the addition of electric flow control valve and inlet and outlet of oil flow. Finally, the effects of oil flow rate, electric s...
متن کاملRate-Based Flow Control
On high-speed networks, the round trip delay from source to intermediate node and back is relatively large compared with packet transmission times; thus, the window-based method of flow control does not react quickly enough to prevent congestion and large delay. An alternative method is to employ a rate-based flow control scheme, in which each node is assigned a maximum rate and an average rate...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1988
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.54.3028