Characterization of defects in plates using shear and Lamb waves
نویسندگان
چکیده
منابع مشابه
Detection of Small Horizontal Defects in Thin Isotropic Plates Using Ultrasonic Rayleigh-Lamb Waves
This paper considers the detection of symmetric crack-like defects in thin metallic plates using longitudinal ultrasonic waves. Only physically small defect sizes are considered in order that the initial stages of crack growth, for example during fatigue, can be detected. This method has the potential to be significantly faster for non-destructively detecting defects than conventional ultrasoni...
متن کاملAttenuation of Lamb Waves in CFRP Plates
The paper presents the Lamb wave attenuation of Carbon Fiber Reinforced Plastic (CFRP) plates on the basis of an experimental transmitter-sensor scheme. We measured separately the S0 and A0 Lamb modes of CFRP plates with three different kind of laminate lay-ups; unidirectional [0]8s (and [90]8s), cross-ply [0, 90]4s, and quasi-isotropic [0,45,-45,90]2s. Several ultrasound transmitters were used...
متن کاملLamb Waves and Nearly-Longitudinal Waves in Thick Plates
We discuss waves created in relatively thick plates by edge excitation at frequency-thickness (fd) products that correspond, in principle, to multiple Lamb wave modes. For relatively low values of the fd product it is clear that Lamb wave modes will be generated, while at large values of the fd product we observe a bulk (longitudinal wave) in the solid, but influenced by reflections from the pl...
متن کاملTransition from Lamb waves to longitudinal waves in plates
We use finite element simulations and experiments to examine the excitation of waves in a plate by normal forces applied to an edge. At low values of the frequency-plate thickness product, f·d, multiple Lamb wave modes are excited with different group velocities, but increasing f·d leads to the formation of a train of well-defined nearly-longitudinal pulses. We investigate the transition betwee...
متن کاملDamage detection in bent plates using shear horizontal guided waves.
Study of the interaction of shear horizontal guided mode with defects in the bend region of an isotropic top hat stiffener is presented. Compared with the SH0 wave in a plate, the shear mode in the bend is dispersive and its wavefield characteristics are affected by the curvature of the bend. The scattering studies showed that the sensitivity of the wave to outer surface cracks in the bend incr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2017
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2017.09.322