Characterization of powder-coated microsponge prepared by dry impact blending method.
نویسندگان
چکیده
منابع مشابه
Dry Wear Behavior of 42CrMo4 Steel/ZrO2 Composite Prepared by Pressure-Less Infiltration Method
The aim of this research was to study the wear behavior of 42CrMo4 steel/ZrO2 composite with 10 and 30 ppi performed ceramic and compare it with the un-reinforced steel under different applied loads. The composite specimens were obtained by pressureless infiltration of the melt into a preformed ceramic of zirconium oxide. The effect of applied load on the specimens wear behavior was ...
متن کاملPrediction of dry powder inhaler formulation performance from surface energetics and blending dynamics.
The purpose of these studies was to investigate the ability of surface energy measurements and rates of mixing in dry powder inhaler (DPI) formulations to predict aerosol dispersion performance. Two lactose carrier systems comprising either spray-dried or milled particles were developed such that they had identical physical characteristics except for surface morphology and surface energies avoi...
متن کاملCharacterization of Structural, Optical and Hydrophilicity properties of TiO2 Nano-Powder Synthesized by Sol-Gel Method
In this paper, titanium dioxide nano-particles were synthesized by sol-gel method in acidic atmosphere. The microstructure, morphology, optical band gap, and hydrophilicity of the sample were studied. Optical band gap of titanium dioxide was probed via Diffuse Reflectance Spectra (DRS) and contact angle (CA) was measured to investigate surface activity. XRD analysis was used to study crys...
متن کاملSynthesis and characterization of Alumina (Al2O3) nanoparticles prepared by simple sol-gel method
Alumina is one of the most widely used ceramic materials as catalysts, catalyst supports and absorbents, and also wear resistant coating. This study focused on fabricating and characterizing of alumina ceramic nanoparticles fabricated using new and simple sol-gel method. Aluminium oxide (Al2O3) nanoparticles were synthesized by iron (III) nitrate 9-hydrate as precursor. Physicochemical properti...
متن کاملSynthesis and characterization of Alumina (Al2O3) nanoparticles prepared by simple sol-gel method
Alumina is one of the most widely used ceramic materials as catalysts, catalyst supports and absorbents, and also wear resistant coating. This study focused on fabricating and characterizing of alumina ceramic nanoparticles fabricated using new and simple sol-gel method. Aluminium oxide (Al2O3) nanoparticles were synthesized by iron (III) nitrate 9-hydrate as precursor. Physicochemical properti...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chemical and Pharmaceutical Bulletin
سال: 1989
ISSN: 0009-2363,1347-5223
DOI: 10.1248/cpb.37.3367