Chatter identification in milling of Inconel 625 based on recurrence plot technique and Hilbert vibration decomposition
نویسندگان
چکیده
منابع مشابه
Identification of a Time-varying Beam Using Hilbert Vibration Decomposition
The present work is concerned by modal identification of time-varying systems. For this purpose, a method based on instantaneous frequency identification and synchronous demodulation is used to extract modal components from recorded signals. The proposed method of iterated sifting process is based on the Hilbert Vibration Decomposition (HVD) technique which is used to extract the instantaneous ...
متن کاملLaser clading of Inconel 625 on ASTM A575 steel
In this research, the microstructure of Inconel 625 cladded layer on ASTM A575 steel has been investigated. By examining different parameters, the optimal single-pass sample with the least amount of dilution, porosity and fusion and suitable wetting angle was determined. Then cladding process with the optimal parameter was performed. The microstructure of the cladding layer was evaluated from t...
متن کاملLaser clading of Inconel 625 on ASTM A575 steel
In this research, the microstructure of Inconel 625 cladded layer on ASTM A575 steel has been investigated. By examining different parameters, the optimal single-pass sample with the least amount of dilution, porosity and fusion and suitable wetting angle was determined. Then cladding process with the optimal parameter was performed. The microstructure of the cladding layer was evaluated from t...
متن کاملOn the Decomposition of Hilbert Spaces
Basic relation between numerical range and Davis-Wielandt shell of an operator $A$ acting on a Hilbert space with orthonormal basis $xi={e_{i}|i in I}$ and its conjugate $bar{A}$ which is introduced in this paper are obtained. The results are used to study the relation between point spectrum, approximate spectrum and residual spectrum of $A$ and $bar{A}$. A necessary and sufficient condition fo...
متن کاملAn Application of Computational Intelligence Technique for Predicting Surface Roughness in End Milling of Inconel-718
In this paper, an attempt has been made to design an computational intelligence technique based expert system using Adaptive Neuro-Fuzzy Inference System (ANFIS) for predicting surface roughness in end milling of Inconel 718. Two different types of membership functions are adopted for analysis in ANFIS training and compared their differences regarding the accuracy rate of the surface roughness ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2018
ISSN: 2261-236X
DOI: 10.1051/matecconf/201814809003