Chemical Solution Processing of Strontium Bismuth Tantalate Films
نویسندگان
چکیده
منابع مشابه
Scanning Tunneling Spectroscopy of Lead - Substituted Bismuth Strontium Copper Oxide
The hole-doped cuprate Bi2-_Pb.Sr 2CulO 6+6 is doped with lead to the solubility limit of x = 0.38 and studied using STM/STS in the overdoped regime where T, < 2K. Despite the high lead content, residual supermodulations are observed in the BiO plane. In agreement with previous studies on (Pb,Bi)-2201, there is no separation of the sample into Pb-rich and Pb-poor domains, nor is there a spectra...
متن کاملChemical solution growth of ferroelectric oxide thin films and nanostructures.
Chemical solution deposition (CSD) provides a low-cost, versatile approach for processing of thin and ultrathin ferroelectric films, as well as short and high aspect ratio ferroelectric nanostructures. This review discusses the state of the art in the processing of ferroelectric oxide thin films and nanostructures by CSD, with special emphasis on nucleation and growth phenomena. The effects of ...
متن کاملSolution-Chemical Synthesis of Cobalt and Iron:Zinc Oxide Nanocomposite Films
Lagerqvist, U. 2016. Solution-Chemical Synthesis of Cobalt and Iron:Zinc Oxide Nanocomposite Films. Digital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Science and Technology 1356. 85 pp. Uppsala: Acta Universitatis Upsaliensis. ISBN 978-91-554-9520-6. The potentially most important challenges today are related to energy and the environment. New materials and methods ar...
متن کاملLow-loss crystal-ion-sliced single-crystal potassium tantalate films
The dielectric response has been studied in 10-mm-thick, single-crystal potassium tantalate films formed by crystal ion slicing. Scanning microwave microscopy shows that the implanted, pre-etched samples exhibit a bulk-like permittivity and low-loss tangent ~0.0009! at 1.7 GHz. The separated free-standing films have somewhat higher loss tangents due to residual-ion-induced stress. Selective rel...
متن کاملPreparation of Bismuth Titanate Films by Electron Cyclotron Resonance Plasma Sputtering-Chemical Vapor Deposition
Bismuth titanate (Bi,Ti,O,, :BIT) thin films were prepared on the Pt courted MgO(100) substrate by electron cyclotron resonance plasma sputtering-chemical vapor deposition (ECR plasma sputtering-CVD). Bi20, was used as a sputtering target and tetra-isopropoxy-titanium [Ti(i-C3H70)4] as a CVD source. The composition of films was controlled by changing RF power (P,,) of Bi,O, target and Ti source...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MRS Proceedings
سال: 1998
ISSN: 0272-9172,1946-4274
DOI: 10.1557/proc-541-259