Chemical vs. mechanical microstructure evolution in drying colloid and polymer coatings
نویسندگان
چکیده
منابع مشابه
Buckling and crumpling of drying droplets of colloid-polymer suspensions.
Spray drying of complex liquids to form solid powders is important in many industrial applications. One of the challenges associated with spray drying is controlling the morphologies of the powders produced; this requires an understanding of how drying mechanics depend on the ingredients and conditions. We demonstrate that the morphology of powders produced by spray drying colloidal polystyrene...
متن کاملMicrostructure and mechanical properties of chromium oxide coatings
Chromium oxide coatings were deposited on low-carbon steel by radiofrequency reactive magnetron sputtering at different oxygen flux values. X-ray diffraction, x-ray photoelectron spectroscopy, and high-resolution transmission electron microscopy were used to investigate the microstructure of chromium oxide coatings. Varying oxygen flux changed the coating microstructure; as with increasing oxyg...
متن کاملChemical Vapor Deposition of Antimicrobial Polymer Coatings
There is large and growing interest in making a wide variety of materials and surfaces antimicrobial. Initiated chemical vapor deposition (iCVD), a solventless lowtemperature process, is used to form thin films of polymers on fragile substrates. To improve research efficiency, a new combinatorial iCVD system was fabricated and used to efficiently determine the deposition kinetics for two new po...
متن کاملWetting, drying, and layering of colloid-polymer mixtures at porous interfaces.
The influence of interface porosity on the wetting properties of colloid-polymer mixtures is studied within density functional theory for the Asakura-Oosawa-Vrij model at the surface of a quenched hard-sphere matrix. While the porosity hardly changes the location of the transition from partial to complete wetting at colloidal bulk gas-liquid coexistence, the onset of wetting, as signaled by the...
متن کاملEffect of TiO2 Particle Concentration on Microstructure and Mechanical Properties of Ni-P-TiO2 Composite Coatings
Ferritic stainless steels are widely used in equipment, including parts in turbines, electrical industries, aerospace, automotive and decorating industries. One of the problems with this type of steels is their low wear resistance. One of the ways to overcome this problem is to apply a wear-resistant coating on the surface of steel. In this research, nickel phosphorus-titanium oxide coating was...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scientific Reports
سال: 2020
ISSN: 2045-2322
DOI: 10.1038/s41598-020-66875-0