Circuit Topologies for MOS-Type Gas Sensor
نویسندگان
چکیده
منابع مشابه
Temperature Control Circuit for Gas Sensor
This paper presents a Temperature Control Circuit for a microhotplate based gas sensor fabricated in standard 0.35/0.18μm CMOS technology. The on-chip microhotplate provide very high temperatures (between 200oC and 400oC), which are necessary for the normal operation of metal oxide sensing layers. The complete temperature control circuit comprises of 10-bit A/D converter, low pass filter, two 1...
متن کاملMOS gas sensor technology for demand controlled ventilation
Due to increasing interest in indoor air quality and demand controlled ventilation in buildings aiming at energy and cost saving, as well as health and comfort aspects, the objective of our work has been the development of a reliable, low cost tool for demand ventilation control. Based on a single microelectromechanical (MEMS) metal oxide semiconductor (MOS) gas sensor VOC detection as close as...
متن کاملOptimized Frequency Shaping Circuit Topologies for LDOs
Typical low drop-out (LDO) regulator architectures suffer from an inherent load regulation performance limitation. This limitation manifests itself through limited dc open-loop gain and results from stringent closed-loop bandwidth requirements. The frequency response of the system is highly sensitive to the loading conditions thereby making proper compensation a laborious endeavor. This paper d...
متن کاملComparison of PFC Circuit Topologies
The equipment connected to an electricity distribution network usually needs rectification. The conventional single phase diode rectifier uses a large electrolytic capacitor to reduce DC voltage ripple, which produces a non-sinusoidal line current. So power factor correction (PFC) techniques are gaining attention now a day. The boost topology is most popular than others in PFC applications. Thi...
متن کاملA low distortion MOS sampling circuit
This paper presents a sampling technique with reduced distortion for use in a sample-and-hold circuit for high resolution analog-to-digital converters and switched capacitor filters. The technique involves bootstrapping both the gate and the bulk terminal of the sampling switch to improve linearity. Circuit implementation and SPICE level simulation results are presented.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electronics
سال: 2020
ISSN: 2079-9292
DOI: 10.3390/electronics9030525