Cladding burst behavior of Fe-based alloys under LOCA
نویسندگان
چکیده
منابع مشابه
Microscopic Analysis and Electrochemical Behavior of Fe-Based Coating Produced by Laser Cladding
The effect of laser cladding on the surface microstructure and corrosion properties of coated/uncoated specimens were investigated. Fe-based alloy coating was produced on 35CrMo steel by laser cladding. The phase composition, microstructure, interface element distribution, microhardness and corrosion resistance of the cladding coating were measured. The results show that the cladding layer is m...
متن کاملPhase Diagrams of Fe-Si Alloys under High Pressures
Introduction Iron is the most abundant element in the Earth’s core. However, the density of the outer core is about 10% lower than the density of iron at the pressure and temperature conditions of the outer core, indicating the presence of a low-atomic-weight component (such as H, C, O, Si, or S) in the core [1]. There is also evidence that the inner core may be less dense than pure iron and th...
متن کاملTransformation Behavior and its Effect on Damping Capacity in Fe-Mn Based Alloys
7 -+ E transformation behavior in a Fe-21Mn alloy with different grain size and a Fe-32Mn-6Si alloy with various degrees of wld rolling is investigated and correlated with damping capacity. Effect of microstructure on damping capacity is discussed on the assumption that the capacity is proportional to volume swept by 7 / e boundaries. 1.INTRODUCTION Fe-Mn based alloys have been well known for s...
متن کاملLaser cladding of copper base alloys onto Al Si7 Mg0.3
Certain copper alloys have proved to be suitable for laser cladding onto aluminium base. By using the blown powder technique with a 1.5 KW C02 laser, clads without cracks or porosity have been produced. The base material has the composition Al Si7 Mg0.3 and the clads are made from alloyed copper with varying contents of Ni, Fe, Si and Al. Aluminium dilution in the clad can be kept lower than 1 ...
متن کاملTernary Ni-Fe-Co Alloys Nanowire Electrodeposition
Nanowire is a cylindrical nano-structure with nanometer dimensions. In this research, the studied nanowire was made from the magnetic triple Ni-Fe-Co alloy. We utilized ordered porous anodic aluminum oxide as a template for the nanowire deposition. The nanowire arrays were electrodeposited in the cylindrical pores of the oxide layer by AC potential in a simple sulfate bath. Then the relation ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Nuclear Materials
سال: 2016
ISSN: 0022-3115
DOI: 10.1016/j.jnucmat.2015.12.018